Loading ...
SB-N-XTERR2/12W3v3_INSTR_SKU#011219
SB-N-XTERR2/12W3v3_INSTR_SKU#011219
CONGRATULATIONS
You have completed the installation for this model!
Please refer to the Power Recommendation section for an
amplifier recommendation and basic set-up help.
STEP 6
From under the vehicle, place the supplied fender washer,
flat washer, lock washer and then hex nut onto to the
exposed socket cup set screw.
Secure the bolt assembly.
Note: For added protection it is recommended that
you apply a bead of silicone between the vehicle and
the fender washer. After the bolt assembly is tightly
secured, it is also recommended that vehicle under-
coating material is applied to the exposed assembly.
STEP 5
Place the Stealthbox® into the cargo area. Run speaker wire
from the amplifier location to the Stealthbox® and attach to
the terminal.
Back out the socket cup set screw, on the bottom of the
Stealthbox®. Leaving 1-1/2-inches exposed.
Place the Stealthbox® into the mounting area. Carefully
guiding the socket cup set screws through spacer and the
drilled hole.
STEP 4
With a Uni-bit or 3/4-inch drill bit, enlarge the 1/2-inch hole
in the plastic flooring to 3/4-inch.
Place the 1/2-inch spacer into the 3/4-inch hole.
Page 3 • JL Audio, Inc 2006
All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered
trademarks of JL Audio, Inc. “Ahead of the Curve” and its respective logo is a trademark of JL Audio, Inc.
JLA-SKU#011219-11-10-200
JLA-SKU#011219-11-10-200
6
6 • Printed in USA • ©2005 JL Audio, Inc. • U.S. PATENTS: #5,734,734 #5,949,898 #6,118,884 #6,229,902
#6,243,479 #6,294,959 #6,501,844 #6,496,590 #6,441,685 #5,687,247 #6,219,431 #6,625,292 #D472,891 #D480,709 Other U.S. & Foreign
patents pending. For more detailed information please visit us online at www.jlaudio.com.
(954) 443-1100
www.jlaudio.com
10369 NORTH COMMERCE PARKWAY • MIRAMAR, FLORIDA • 33025 • USA
INCLUDED HARDWARE
(1)
(1)
3-inch x 3-inch Wax Square
3-inch x 3-inch Wax Square
(1)
(1)
3/8-16 x 2-1/4-inch Socket Cup Set Screw
3/8-16 x 2-1/4-inch Socket Cup Set Screw
(1)
(1)
3/8-inch x 3/4-inch USS Flat Washer
3/8-inch x 3/4-inch USS Flat Washer
(1)
(1)
3/8-inch-16 Hex Nut
3/8-inch-16 Hex Nut
(1)
(1)
3/8-inch x 2-inch Fender Washer
3/8-inch x 2-inch Fender Washer
(1)
(1)
3/8-inch(L) x 3/4-inch(OD) x 3/8-inch(ID) Spacer
3/8-inch(L) x 3/4-inch(OD) x 3/8-inch(ID) Spacer
(1)
(1)
3/8-inch Split Lock Washer
3/8-inch Split Lock Washer
SPECIFICATIONS
Enclosure Type:
Acoustic Suspension (sealed)
Acoustic Suspension (sealed)
Driver Type:
12W3v3-4
12W3v3-4
Nominal Impedance:
4 ohms mono
4 ohms mono
Continuous Power Handling:
300 Watts
300 Watts
POWER RECOMMENDATION
JL Audio recommends using a high quality amplifier such as the JL Audio 250/1.
The diagram below shows the recommended crossover, infrasonic filter and equalizer settings for the 250/1 when
being used to power your Stealthbox
®
.
JL AUDIO 250/1
monoblock subwoofer amplifier
Amplifier Input Section
Input Sens.
Input Voltage
Low/High
Left Ch.
Right Ch.
Signal Sensing
Off/On
Output Mode
Full-Range/Low-Pass/High-Pass
Left Ch.
Right Ch.
Amp LP Filter
Mode/Slope
Off/12dB/24dB
Filter Freq. (Hz)
Bass Control
LF Boost (dB)
Off/30Hz
Infrasonic Filter
+1
+13
+3
+7
+10
Preamp Output Section
+12VDC Ground Remote
The JL Audio 250/1 is a very versatile audio component. Please consult the owner’s manual for even more
detailed information about installing and tuning this amplifier.
MID/HIGH FREQUENCY DRIVER FITMENT
A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of you vehicle.
Front Speaker Size / Location:
6-1/2-inch / Front Doors
6-1/2-inch / Front Doors
Fits JL Audio Models:
TR650-CXi, VR650-CSi, VR650-CXi, XR650-CSi, XR650-CXi & ZR650-CS
TR650-CXi, VR650-CSi, VR650-CXi, XR650-CSi, XR650-CXi & ZR650-CS
i
i
Rear Speaker Size / Location:
6-inch x 9-inch / Rear Panels
6-inch x 9-inch / Rear Panels
Fits JL Audio Models:
N/A
N/A
STEALTHBOX WALL
THREADED INSERT
VEHICLE SHEET METAL
FENDER WASHER
SOCKET CUP SET SCREW
LOCK WASHER
FLAT WASHER
HEX NUT
SILCONE SEALANT