Loading ...
Loading ...
Loading ...
15
Cleaning Filter Cover Panel
• Open the Panel by pulling it down.
• Clean the outside with a damp cloth and neutral detergent.
• Clean the inside using a damp cloth and neutral detergent.
Do not use wet cloths or sponges, or jets of water; do not
use abrasive substances.
Cleaning metal grease lters
The metal grease lters can be cleaned in hot detergent
solution or washed in the dishwasher. They should be
cleaned every 2 months use, or more frequently if use is
particularly heavy.
• Open the Panel by pulling it down.
• Remove the lter, pushing the lever towards the back of
the unit and at the same time pulling downward.
• Wash the lter without bending it, leave it to dry thorou-
ghly before replacing (if the surface of the lter changes
color over time, this will have absolutely no effect on its
efciency).
• Replace, taking care to ensure that the handle faces
forward.
• Cleaning in dishwasher may dull the nish of the metal
grease lter.
• Close the Panel.
• No water can be present in lters before installing back
in hood.
Replacing Activated Charcoal Filter
The Activated Charcoal Filters are not washable and cannot
be regenerated, and must be replaced approximately
every 4 months of operation, or more frequently with heavy
usage.
• Open the Panel by pulling it down.
• Remove the Filter, pushing it towards the back of the unit
and at the same time pulling downward.
• Remove the saturated Activated Charcoal Filters, as
indicated (A).
• Fit the new Filters, as indicated (B).
• Replace, taking care to ensure that the handle faces
forwards.
• Close the Panel.
CAUTION: When used in recirculation mode, to Reduce
the Risk of Fire and Shock use only conversion kit Model
FILTER 1 or FILTER1LL.
Lighting unit
• LED lights must be replaced by Faber factory au-
thorized service.
EN
7
7
INSTALLATION
Fitting the Hood canopy
BEFORE FITTING THE HOOD TO THE WALL UNIT, PROCEED AS FOLLOWS:
• Disconnect the wires to the Commands at the connectors.
• Disconnect the wires to the Light at the con-
nectors.
• The Hood can be installed directly on the
underside of
the wall unit (Minimum 650 mm
from the Cooker Hob).
• Create an opening in the bottom of the wall unit,
as shown.
• Insert the hood until the side supports snap into
place.
• Fasten using the 10 screws 12a provided.
• Lock in position by tightening the screws Vf from
underneath the hood.
• Open the suction panel by turning the specific knob.
• Disconnect the panel from the hood canopy by sliding the
fixing pin lever.
• Remove grease filters.
• Screw the Frame into place
using the 6 scr
ews 12f, re-
connect the wires to the
Commands and Light, re-
place the metal grease filter
and the Panel.
260
13
495 - 675
Loading ...
Loading ...
Loading ...