Loading ...
Loading ...
Loading ...
en Basic operation
14
Making ice cubes
1. Fill the ice cube tray with water up
to ¾ and place in the freezer com-
partment.
If the ice cube tray is stuck to the
freezer compartment, loosen with a
blunt implement only (e.g. spoon
handle).
2. To loosen the ice cubes, twist the
ice cube tray slightly or hold briefly
under flowing water.
Basic operation
Basic operation
You can find out everything you need
to know about operating your appli-
ance here.
Switching on the appliance
1. Press .
a The appliance begins to cool.
2. Switch off the warning signal with
.
a goes out as soon as the set
temperature has been reached.
3. Set the required temperature.
→Page14
Operating tips
¡ Once you have switched on the
appliance, the set temperature is
only reached after several hours.
Do not put in any food in the appli-
ance until the temperature is
reached.
¡ The front panels of the housing are
temporarily heated slightly. This
prevents condensation in the area
of the door seal.
¡ When you close the door of the
freezer compartment, a vacuum
may be created and you may not
be able to open the freezer door
again immediately. Wait a moment
until the vacuum is offset.
¡ The refrigeration system may
cause several areas of the freezer
shelves to frost quickly. The frost
has no effect on the function or the
energy consumption of the appli-
ance. If frost or ice thicker than
5mm has formed on the entire
surface of the freezer shelf, the ap-
pliance must be defrosted.
Switching off the appliance
▶
Press .
a The appliance stops cooling.
Setting the temperature
After you have switched on the appli-
ance, you can set the temperature.
Setting the freezer compartment
temperature
▶
Use a coin to set the temperature
at the temperature controller.
The higher the number, the lower
the temperature.
The middle setting is recommen-
ded by the factory.
Loading ...
Loading ...
Loading ...