Loading ...
Loading ...
Loading ...
Customer ServiceTroubleshooting Tips
Operating Instructions
Safety Instructions
Installation Instructions
Repeat steps 2 through 7 for the other filter.
Open the filtered water faucet. Then, slowly open the water supply/saddle valve and allow the filter
housing to fill. While it is filling, press the filter vent valve to release air in the filter.
Close the filtered water faucet. Then, check for leaks between the sump and the head.
NOTE:
If leaking, turn off the water supply and open the filtered water faucet, or press the vent valve to
depressurize the filter. Then,
disassemble the filter and check the o-ring for cuts, flat spots, etc., and
sealing surfaces for foreign material. Clean the o-ring and lubricate with clean silicone grease. Carefully
press into the groove in the sump.
The filter cartridges contain activated carbon, a black powder. When new, open the filtered water faucet
for ten minutes to allow fine, harmless carbon particles to purge from the cartridge. Air suspended in
the water may also cause a cloudy appearance. This air is harmless and should dissipate quickly.
11
10
9
8
Fig. 4
Fig. 5
Vent
valve
Filter Ι
Filter Ι
Filter ΙΙ
O-ring seal
Cartridge
Sump
Sump
Replacement label
Sump
Mounting
screws
Tubing
connector
Tubing
connector
Mounting
bracket
TURN SUMP
TO INSTALL
TURN SUMP
TO REMOVE
Head
Bracket
Sump
7-9⁄16″
1-1⁄2″to 2″
Sump
wrench
To
loosen
11
Filter ΙΙ
Loading ...
Loading ...
Loading ...