Loading ...
Loading ...
Loading ...
E
Changing the dust bag
The dustbag needs changing when the
cleaner is set to maximum power and the
cleaner head is off the floor but the “bag full”
indicator window(19) is completely coloured
red.
Even if the dustbag does not appear to be full
at this stage, it should be changed.
It could be that a great deal of very fine dust
has clogged up the pores of the dust bag.
• Turn off the appliance and unplug it.
• Open the cover by pressing the hook(20) and
lifting it up until it snaps into place.
Your appliance is equipped with either a paper
dust bag (21) or a fabric dust bag (23)
(depending on model).
• Take hold of the dust bag by the handle and
pull. Remove the bag and throw it away.
• To refit a new bag push the cardboard
support of a new bag into the bag mount (22)
until it will go no further.
If your appliance is fitted with a fab-ric
dust bag
follow the same instructions as
above.
Empty it and replace it(23).
Note: as the appliance is fitted with a safety
device which checks that the bag is in place
you cannot close the lid if the bag is not fitted
correctly.
Cleaning the motor filter
The motor filter is situated inside the appliance
between the dust bag and the motor. Each
time that you change the air outlet filter we
advise you to remove the motor filter(24) and
to clean it by tapping to remove the dirt and
then replacing it in the vacuum cleaner.
Changing the air outlet filters(Optional)
•
• You can perform cleaning at any place
like corner or crevice since revolution of
the suction hole is free (30).
(depending on model)
What to do if your appliance
does not work?
Check that the appliance is correctly plugged
in and that the electrical socket is working.
What to do when the suction
performance reduces?
• Stop the appliance and unplug it.
• Check that the tubes, flexible hose and
cleaning tool are not blocked.
• Check that the dust bag is not full.
Replace if necessary.
• The washable HEPA filter
(26)
should be
cleaned with water at least every 6 months.
• Turbine brush nozzle (27)
(depending on model)
• Cleaning turbine brush nozzle (29)
• Easy & Powerful cleaning through
adjusting the air-control lever (28).
Press the button the rear side of the
nozzle to separate the air cover.
Use the dusting brush & crevice tool
to vacuum clean the brush and fan.
: use for hard floor & short
type carpet.
: use for long type carpet.
To change filter
(26)
remove the cover of
the filter compartment
(25)
situated at the
rear of the appliance.by pressing the little
button.
– 5 –
Loading ...