Loading ...
Loading ...
Loading ...
Optional Components
25
GB
Where to place the transmitter
Placing it up off the floor, such as on a desk, is
recommended.
Notes
• Do not place the transmitter on or near the following
objects. Doing so may cause noise.
– Main unit, TV, speaker, fluorescent lamp, floor.
– Radio waves generated such as cell phones and
cordless phone systems or metal instruments are
placed on the unit.
– Inside a building with walls containing steel
beams.
– Area with many steel file cabinets, etc.
– Area with many electrical appliances capable of
generating electromagnetic noise.
– Area facing roadways.
– Radio transceivers in trucks, etc.
– Wireless communication systems installed along
roadways.
• Even within the signal reception area, there are some
spots (dead spot) where the RF signal cannot be
received. This is a characteristic inherent to RF
signals, and does not indicate a malfunction. By
slightly moving the transmitter, the location of the
dead spot can be changed.
Hooking up the transmitter
(European model only)
You can use the wireless stereo headphone
system (MDR-RF820RK) as a transmitter by
hooking it up to an optional component.
For details on how to hook up and place this
system, refer to the operating instructions of the
MDR-RF820RK.
To listen to audio using this system, see
“Listening to audio using the wireless system”
on page 25.
Notes
• To use the MDR-RF820RK as a wireless stereo
headphone system, use the connecting cord to plug
the headphone system into the PHONES jack of the
main unit. For details, refer to the operating
instructions of the MDR-RF820RK.
• Turn down the volume on the main unit before
charging the batteries. When placing the wireless
headphones on the transmitter to charge the
headphone batteries, RF signals are not sent from the
transmitter and noise may be output.
• The optimum distance between the transmitter unit
and the main unit is shorter than the distance between
the transmitter unit and the wireless headphones.
Listening to audio using the
wireless system
1 Start playing the connected
component.
2 Press FUNCTION repeatedly to switch
the function to WIRELESS.
(European model only)
Change the color of the CHG indicator on
the transmitter unit from green to red (or
remove the wireless headphones from the
transmitter).
3 Press +/– (or TUNING +/– on the unit).
“AUTO SCAN” appears.
If the system picks up some
noise or “AUTO SCAN” does not
disappear
• Reduce the distance between the transmitter
unit and the main unit.
• Select another channel using CHANNEL 1–3
on the transmitter, then press +/– (or
TUNING +/– on the unit). “AUTO SCAN”
appears.
Notes
• You may not hear the beginning of the sound from
the main unit until the transmitter starts sending the
RF signals after detecting an audio signal.
• If the transmitter is connected to the headphones jack
of the source component, set the volume of that
component as high as possible without distorting the
audio signal.
• If you hold the antenna of the transmitter with your
hand, noise may occur. However this is not a
malfunction.
• When the transmitter is not to be used for a long
period of time, disconnect the AC power adaptor
from the wall outlet holding the plug. Do not pull on
the cord.
Loading ...
Loading ...
Loading ...