Loading ...
Normal noise during operation
Information
Before putting your laundry into the dryer, remove all objects
(especially lighters, metal parts or similar objects) from
pockets. Note the maximum load quantity. You must also
observe the information in the chapter “Notes on laundry” in
the instruction manual.
Removing objects before drying
The buttons are sensitive and it is sufficient to lightly touch them. If you select a button
more than once (especially when setting the options), then you must let the button go
after each selection in order to activate the sensor. Your selection will be followed by
a button acknowledgement.
Selecting buttons more than once
The drying operation can be paused for a short period to add more laundry, remove
laundry or for programme changes. Depending on the model, the display “Finished
in” is reset and restarted or stopped. After a while, the display is then corrected. To
ensure that the heat exchanger is automatically cleaned, programmes must then
always be allowed to continue until they end. Do not cancel a drying cycle before the
programme automatically ends.
Interrupting/changing the programme
Cleaning agents and agents for pretreating laundry (e.g. stain removers, prewash
sprays, etc.) must not come into contact with the surfaces of the dryer. If necessary,
immediately wipe away spray residue and other residues/droplets with a damp cloth.
You must also observe the information in the chapter “Care and cleaning” in the
instruction manual.
Laundry additives/care and cleaning
!
When a programme is selected, the anticipated drying time for the maximum load is
displayed. While drying, the appliance's sensors detect the actual load and its level
of moisture, and they correct the programme length. This is shown in the display by
jumps in the “Finished in” time.
“Finished in” appears in the display
--:--
The compressor in the dryer generates a humming noise. The
volume and pitch of this may vary.
Humming noise
From time to time, the compressor in the dryer is cooled by a fan
and this creates a whirring sound.
Whirring
The start of the automatic cleaning cycle for the heat exchanger
causes a clicking noise.
Clicking
Rushing water can be heard during the automatic cleaning cycle.
Noise
The process of pumping the condensation into the condensation
container generates pumping noises.
Pumping
Rattling noises may be caused by the laundry moving if hard parts,
such as buttons, zips, buckles or similar parts, are part of the
laundry.
Rattling
Humming...
Click...
Shsh...
Slurp...
Sssssss...
Rattle...
Please note: During drying, the compressor, the pump and the movement of the laun-
dry generate noises which are entirely normal.
During the automatic cleaning cycle, “cln”
(Clean) or “Heat exchanger is being rinsed”
appears in the display.
During the automatic cleaning cycle, “cln”
(Clean) or “Heat exchanger is being rinsed”
appears in the display.
You must pay particular attention to the safety information and the chapter “What to
do if...” in the instructions for use.