Loading ...
Loading ...
Loading ...
-4-
MIII TOOL SPECIFICATIONS
OPERATION
All screws and nuts are english.
FASTENER SPECIFICATIONS:
TOOL AIR FITTING:
This tool uses a 3/8” N.P.T. male plug. The inside diameter should be .275” (7mm) or larger.
The fitting must be capable of discharging tool air pressure when disconnected from the
air supply.
OPERATING PRESSURE:
70 to 90 p.s.i.g. (4.9 to 6.3 kg/cm
2
). Select the operating pressure within this range for
best fastener performance.
DO NOT EXCEED THIS RECOMMENDED OPERATING PRESSURE.
AIR CONSUMPTION:
The MIII requires 4.2 cubic feet per minute (221 liters per minute) of free air to operate at the
rate of 60 fasteners per minute, at 80 p.s.i. (5.6 kg/cm
2
). Take the actual rate at which the tool
will be run to determine the amount of air required. For instance, if your fastener usage
averages 30 fasteners per minute, you need 50% of the tool’s c.f.m. of free air which is required
to operate the tool at 60 fasteners per minute.
MODEL LENGTH HEIGHT WIDTH WEIGHT
MIIIFS 17-1/4” (438mm) 11-1/2” (292mm) 3-1/8” (80mm) 11.2lbs (5.1kg)
MIIIFN 17-1/4” (438mm) 11-1/2” (292mm) 3-1/8” (80mm) 11.2lbs (5.1kg)
MODEL FASTENER CROWN WIDTH WIRE SIZE MAX LENGTH
MIIIFS BCS1500 1/2” (13mm) 15-1/2 Ga. 2” (50mm)
MIIIFN FLN-200 - - 2” (50mm)
Caution Regarding Use of this Tool to Install Pre-finished Flooring
This MarkIII Flooring Tool was designed for use in installing unfinished
hardwood flooring. It can be used to install pre-finished flooring however
caution must be used to ensure that the finish is not damaged by the tool.
It is recommended that the tool be tested on a sample section to be certain
that the tool and technique of use do not leave marks on the finish. This pro-
cedure should be followed before each job due to variations in flooring and
tool condition.
Loading ...
Loading ...
Loading ...