Loading ...
Loading ...
Loading ...
8
Setup 3:Secure the cords and
close the back cover
1 Slide up the back cover.
2 Remove the stand cover.
3 Secure the power cord and video signal cable using
the cable holder on the cabinet (SDM-S53/S73).
Secure the video signal cable using the cable holder
on the cabinet (SDM-S93).
4 Feed the power cord and the video signal cable into
the stand, and secure them using the cable holder
(SDM-S53/S73).
Feed the power cord through the hole on the left of
the stand and secure the power cord and video
signal cable using the cable holder inside (SDM-
S93).
5 Replace the stand cover and then slide down the
back cover.
Please be sure that cords come out through the opening at the
bottom of the stand cover, for proper placement of the stand
cover.
SDM-S53/S73
SDM-S93
Setup 4:Turn on the monitor and
computer
1 Press the MAIN POWER switch located on the right
side of the monitor in the direction of the [, if it is not
already pressed. Make sure the 1 (power) indicator
is lit in red.
Note
The monitor is factory shipped with the MAIN POWER switch set to on
([).
2 Press the 1 (power) switch on the front right of the
monitor.
The 1 (power) indicator lights up in green.
back cover
Illustrations of monitor rear are the SDM-S53.
The same applies for the SDM-S73 model.
cable holder
stand
cover
cable holder
1
3
2
4
back cover
cable holder
stand
cover
cable holder
1
3
4
2
MAIN POWER
lights in red
lights in green
Loading ...
Loading ...
Loading ...