Loading ...
Loading ...
Loading ...
9
Operation and Controls
ACTIVE CHARCOAL FILTER
The Whynter FWC-1201BB is equipped with an activated charcoal filter, which ensures optimum air quality within
the wine cabinet. This filter counters and prevents any contaminants and odors from the ambient air affecting the
taste of the wines stored.
Replace the active charcoal filter with new one once a year. It can be purchased from the retailer or Whynter’s
Service Department.
To change the filter,
Turn the filter cover 90° clockwise or counterclockwise and then remove the
filter.
Insert the new filter in the vertical position.
Turn the filter cover 90° clockwise or counterclockwise until it click
into position.
WINE SHELVES
This wine cabinet refrigerator is equipped with 4 removable shelves. If you are having trouble fitting the stated
listed number of bottles of wine in the wine cabinet refrigerator, try flipping the wine racks over. To prevent dam-
age to the door gasket, make sure the door is all the way opened when pulling the shelves out.
For easy access of the wine bottles, you must pull the shelves approximately ⅓ out of the railing.
When removing the shelves out of the railing, make sure to remove all items first.
To remove any of the shelves from the rail compartment, move the shelf to the position where the notch of
shelf is exactly under the plastic post and then lift it up and out.
In order to replace the shelves, repeat steps described above in reverse
STORAGE
Wine bottles may differ in size and dimensions so the actual number of bottles can be stored may vary. The 124
bottle capacity is approximate maximum when storing traditional Bordeaux 750 ML bottles and includes bulk stor-
age.
You may load your wine bottles in single row or by stacking while taking note of the following: if you do not
have enough bottles to fill your wine refrigerator, it is better to distribute the load throughout the wine re-
frigerator so as to avoid “all on top” or “all below” type loads.
You can remove or relocate adjustable shelves to accommodate larger type of bottles
Keep small gaps between the walls and the bottles to allow air circulation.
Do not over load your wine refrigerator
Avoid obstructing the internal fans (located inside on the back panel of the wine refrigerator).
Do not try to slide the shelves outwards beyond the fixed position to prevent the bottles from falling.
Do not pull out more than one loaded shelf at a time as this may cause the wine refrigerator to tilt forward
if not properly installed.
NORMAL SOUNDS
The unit is cooled by a compressor. The compressor pumps coolant through the cooling system, producing oper-
ating noise. Even when the compressor cuts out, noises caused by changes in temperature and pressure are
unavoidable. Operating noise will be most audible immediately after the compressor comes on. It becomes quiet-
er as the operating period continues.
The following noises are normal and occur from time to time:
Gurgling sound, caused by the refrigerant flowing through the appliance’s coils,
Humming noise made by the compressor. This noise can get louder for brief periods when the motor is
switching on.
Cracking/popping sounds, resulting from the materials contraction and expansion due to temperature varia-
tions,
Fan operating sound, to circulate the air within the wine cabinet.
Unusual noise is normally the result of improper installation.
Where the unit is installed in open-plan kitchen or in partition walls, the level of operating noise will be heard
more acutely. However, this is due to the surrounding architecture and not to the unit.
NOTE: An individual’s perception of noise is directly linked to the environment in which the unit is locat-
ed, as well the specific type of models. Our appliances are in line with international standards for such appliance
and in line with the latest technical developments. Please remember that the noise of the compressor and the
coolant circulating in the system is unavoidable.
Loading ...
Loading ...
Loading ...