Loading ...
Loading ...
Loading ...
6
5- IS THERE A PROBLEM ?
Problems Possible causes Solutions
• The iron does not heat up
• Water drips from the holes in the
sole plate
• Brown streaks come through the holes
in the sole plate and stain the linen.
• The sole plate is dirty or brown and
can stain the linen.
• There is little or no steam.
• The sole plate is scratched or
damaged.
• The auto-stop safety switch has operated
• Thermostat control not correctly positioned.
• The chosen temperature is too low and does not
allow for the formation of steam.
• You are using steam while the iron is not hot
enough.
• You are using the Shot of steam button too
often.
• The steam flow is too high.
• You have stored the iron horizontally,
without emptying it and without setting it to DRY.
• You are using chemical descaling agents.
• You are using pure distilled water.
• Fabric fibres have accumulated in the holes of
the sole plate and are burning.
• Your linen is not rinsed sufficiently or you have
ironed a new garment before washing it.
• You are using too high a temperature.
• You are using starch.
• The water tank is empty.
• The anti-calc valve is dirty.
• Your iron has a build-up of scale.
• You iron has been used dry for too long.
• You have placed your iron flat on a metallic rest-plate.
• You have ironed over a zip.
• Restart the iron by lightly moving it.
• Set the thermostat control to the required
fabric to be ironed.
• Set the thermostat in the coloured zone
(from ●● to MAX)
• Wait until the thermostat light goes out.
• Wait a few seconds between each use of the
button.
• Reduce the steam flow.
• See the section "Storing your iron".
• Do not add any descaling agents to the
water in the water tank.
• Do a self-cleaning and use tap water or 50 % tap
water and 50 % demineralized water.
• Do a self-cleaning.
Clean the sole plate with a non-metallic sponge.
Vacuum the holes of the sole plate from time
to time.
• Ensure linen is rinsed thoroughly to remove any
soap deposits or chemicals on new garments
which have been sucked up by the iron.
• Clean the sole plate as indicated above. See the
temperature table to correctly set the thermostat.
• Clean the sole plate as indicated above.
Always spray starch onto the reverse side of
the fabric to be ironed.
• Fill it with tap water.
• Clean the anti-calc valve.
• Clean the anti-calc valve and do a self-cleaning.
• Do a self-cleaning.
• Always set your iron on its heel.
• Try to avoid ironing over zips which may have
rough edges.
THIS PRODUCT HAS BEEN DESIGNED FOR DOMESTIC USE ONLY. ANY PROFESSIONAL USE, INAPPROPRIATE USE OR FAILURE TO COMPLY
WITH THE INSTRUCTIONS
,THE MANUFACTURER ACCEPTS NO RESPONSIBILITY AND THE GUARANTEE WILL NOT APPLY.
Loading ...
Loading ...
Loading ...