Loading ...
Loading ...
Loading ...
10
Connect speakers
Note
Insert the stripped portion of each speaker wire into
the socket completely.
For the optimal sound, use the supplied speakers only.
Connect speakers only with impedance that is the same
or higher than that of the supplied speakers.
Two speaker cables are supplied. Each speaker
cable has two strands.
the red strand for the connectors marked
with “+”
the silvery strand for the connectors
marked with “-”
1 Unscrew the connectors for speaker cable
on this product and the speakers.
2 Connect a speaker cable to the left
speaker and the SPEAKER OUT L (+/-)
connectors on this product.
3 Screw the connectors to secure the cable.
4 Connect the other speaker cable to the
right speaker and the SPEAKER OUT R
(+/-) connectors on this product.
5 Screw the connectors to secure the cable.
Connect the control cable
Fully insert the control cable connector to the
CONTROL CABLE socket.
a
a
3 Before use
Place the product
Place the speakers at an angle of approximately
45 degrees from the listening position.
Note
To avoid magnetic interference or unwanted noise,
never place this product too close to any radiation
devices.
Connect
Make the following connections to use this
product.
Note
Refer to the type plate at the back or bottom of the
Before you make or change any connections, make sure
that all the devices are disconnected from the power
outlet.
The DEMO jack is only applicable to the demo unit
that is not included in the apparatus. Do not attempt
to connect any other device to the apparatus through
this jack.
EN
Loading ...
Loading ...
Loading ...