Loading ...
Loading ...
Loading ...
9
CoolFun CA-35
Connecting to 12 V DC
You cannot set the temperature with the thermostat control during battery
operation. The device is simply switched on and starts cooling.
Disconnect the cooler from the battery when the engine is not running as
otherwise the battery will be completely run down.
➤ Make sure that the cable from the battery to the cooler is protected by
a fuse (max. 15 A).
➤ Select a cable cross section for the cable between the battery and the
socket of the 12 V voltage supply in accordance with the following table:
Cable length Cable cross section
Up to 2.5m 2.5 mm
2
2.5 m to 4.0 m 4.0 mm
2
➤ Make sure that the thermostat control for 220 V – 240 V operation ( 2 2,
page 4) is in the “0” position.
➤ Insert the plug of the connection cable into the 12 V socket (e.g. cigarette
lighter). The polarity cannot be reversed.
➤ To switch off the cooler, pull the plug out of the socket.
Connecting to a gas source
Only use LPG gas bottles with an approved pressure regulator fitted.
Compare the pressure information on the type plate with the pressure
information on the gas cylinder.
The device is fitted with a pilot light. The gas supply is interrupted when the
flame goes out.
➤ Position the gas bottle vertically at a distance of at least 1 metre away
from the burner (on the back of the cooler).
➤ Check if the valve on the gas bottle is closed.
Only use approved hose lines (regulated to 2.75kPa) with a maximum length of
1.5m.
➤ Connect the hose line to the head of the valve on the gas bottle and the
cooler ( 3 1, page 4).
The thread required is RH 1/4” BSP
➤ Make sure that the hose line
– Is not crushed or kinked
– Is a safe distance from the burner.
➤ Open the valve on the gas bottle.
Never check for leaks with an open flame or near sources of ignition.
➤ Check all connections with a leakage test spray.
There are no leaks if no bubbles form.
CA-35_M-51201 2/3/06 8:29 AM Page 9
Loading ...
Loading ...
Loading ...