Loading ...
Loading ...
Loading ...
10
US
TMR-BT10A_U2 [US,ES] 3-280-223-11(1)
Pairing
What is pairing?
Bluetooth devices need to be
“paired” with each other beforehand.
Once Bluetooth devices are paired,
there is no need for pairing again,
except in the following cases:
• When pairing information is
deleted after repair, etc.
• When this unit is paired with 9 or
more devices.
This unit can be paired with 8
Bluetooth devices; if a new device
is paired after 8 devices have been
paired, the device whose latest
connection time is the oldest
among the 8 paired devices is
replaced by the new one.
• When recognition of the unit by
the device to be connected is
deleted.
• When this unit is initialized
(page 20).
All pairing information is deleted.
Note
Passcode* of this unit is fixed at “0000.”
This unit cannot be paired with a
Bluetooth receiving device whose
Passcode is not “0000.”
* Passcode may be called “Passkey,”
“PIN code,” “PIN number,” or
“Password.”
Procedures of pairing
1 Place a Bluetooth
receiving device within
1 m (3 ft) of this unit.
2
Press and hold the
POWER button for 7
seconds or more to
standby for pairing while
the unit is turned off.
The indicator (blue) and the
indicator (red) start flashing
together and this unit starts
searching the Bluetooth
receiving device.
Notes
• After about 3 seconds, power is
turned on and the indicator
(blue) and indicator (red) flash
together twice. Keep the button
pressed without releasing until
both indicators start flashing
together, then release the button.
This unit enters into pairing
mode.
•
If pairing is not established
within about 5 minutes, pairing
mode will be canceled and this
unit will turn off. In this case,
start over from step 1.
01US03GET+U2.p65 8/8/07, 1:27 pm10
Loading ...
Loading ...
Loading ...