User Manual Frigidaire FFRH1122UE 11,000 Btu Window-mounted Room Air Conditioner 

• User Manual - (English, French, Spanish)

• Guide d'utilisation complet - (French)
• Propietario completa Guía - (Spanish)
• Energy Guide - (French)
• Installation Instructions - (English)
• Product Specifications Sheet - (English)

User Manual Room Air Conditioner Frigidaire FFRH1122UE

Table of Contents

• Important Safety Instructions
• Product Registration 
• Packaging 
• Normal Sounds 
• Air Conditioner Features 
• Operating Instructions
• Care and Cleaning 
• Energy Saving Ideas
• Before You Call 
• Major Appliance LimitedWarranty

Care and Cleaning & Energy Saving Ideas

Care and Cleaning

Air Filter Cleaning

The air filter should be checked at least once a month to see if cleaning is necessary. Trapped particles in the filter can build up and cause an accumulation of frost on the cooling coils.

• Push the vent handle to the Vent Closed position(where applicable).
• Open the front panel.
• Grasp the filter by the center and pull up and out.
• Wash the filter using liquid dishwashing detergent and warm water. Rinse filter thoroughly. Gently shake excess water from the filter. Be sure filter is thoroughly dry before replacing
• Or instead of washing, you may vacuum the filter clean.

Cabinet Cleaning

• Be sure to unplug the air conditioner to prevent shock or fire hazard. The cabinet and front may be dusted with an oil-free cloth or washed with a cloth dampened in a solution of warm water and mild liquid dishwashing detergent. Rinse thoroughly and wipe dry.
• Never use harsh cleaners, wax or polish on the cabinet front.
• Be sure to wring excess water from the cloth before wiping around the controls. Excess water in or around the controls may cause damage to the air conditioner.
• Plug in air conditioner.

Winter Storage

• If you plan to store the air conditioner during the winter, remove it carefully from the window according to the installation instructions. Cover it with plastic or return it to the original carton.

Energy Saving Ideas

• Do not block air flow inside with blinds, curtains or furniture; or outside with shrubs, enclosures, or other buildings.
• The capacity of the room air conditioner must fit the room size for efficient and satisfactory operation.
• Install the room air conditioner on the shady side of your home. A window that faces north is best because it is shaded most of the day.
• Close the fireplace damper, floor and wall registers so cool air does not escape up the chimney and into the duct work.
• Keep blinds and drapes in other windows closed during the sunniest part of the day.
• Clean the air filter as recommended in the section “Care and Cleaning”.
• Proper insulation and weather stripping in your home will help keep warm air out and cool air in.
• External house shading with trees, plants or awnings will help reduce the air conditioner’s work load.
• Operate heat producing appliances such as ranges, washers, dryers and dishwashers during the coolest part of the day.

Before You Call

Air conditioner will not operate.

• Wall plug disconnected. Push plug firmly into wall outlet.
• Plug Current Device Tripped. Press the RESET button.
• House fuse blown or circuit breaker tripped. Replace fuse with time delay type or reset circuit breaker.
• Control is OFF. Turn Control ON and set to desired setting.

Air from unit does not feel cold enough.

• Room temperature below 60°F (16°C). Cooling may not occur until room temperature rises above 60°F (16°C).
• Temperature sensing element touching cold coil, located behind air filter. Straighten away from coil.
• Compressor shut-off by changing modes. Wait approximately 3 minutes and listen for compressor to restart when set in the COOL mode.
• Reset to a lower temperature.

Air conditioner cooling, but room is too warm - ice forming on cooling coil behind decorative front

• Outdoor temperature below 60 F (16 C). To defrost the coil, set FAN ONLY mode. 
• Air filter may be dirty. Clean filter. Refer to Care and Cleaning section. To defrost, set to FAN ONLY mode.
• Temperature is set too low for night-time cooling. To defrost the coil, set to FAN ONLY mode. Then, set temperature to a higher setting.