Loading ...
Loading ...
Loading ...
5
Adjusting Valve Bypass Screw
NOTE: The valve bypass adjustment is only required when
converting from Natural Gas to LP Gas. The bypass adjustment is
only required for single burner valves. The dual burner valves do
not require bypass adjustment because their low flame is
controlled by the burner simmer orifice.
1. Use a ¹⁄₈" x 4¼" flat-blade screwdriver to completely screw
down all single burner valves bypass screws. Do not
overtighten.
2. Reassemble range or cooktop in reverse order used when
gaining access to the burner valves.
To Convert Surface Burners
1. If installed, remove the burner grates.
2. Remove burner cap.
3. Remove the burner base.
4. Apply masking tape to the end of a 7 mm nut driver to help
hold the gas orifice spud in the nut driver while changing it.
Insert nut driver into the gas opening and press down onto
the gas orifice spud and remove by turning the gas orifice
spud counterclockwise and lifting out. Set gas orifice spud
aside.
5. Replace with correct LP gas orifice spud. See the “LP Gas
Orifice Spud/Hood Chart.”
Use the following chart to find the exact orifice spud
placement.
Fully insert choke into bottom of medium burner base. Choke
should snap into place.
Gas Orifice Spud/Hood Chart
6. Place the original gas orifice in plastic parts bag for future use
and keep with package containing literature.
7. Replace the burner base.
8. Replace burner cap.
9. Repeat steps 2 through 8 for the remaining burners.
IMPORTANT: LEAK CHECK - Refer to the “Make Gas
Connection” section of the Installation Instructions supplied
with your appliance for proper leak check procedure.
10. Plug in appliance and turn on gas supply.
IMPORTANT: Refer to the “Electronic Ignition System”
section of the Installation Instructions supplied with your
appliance for proper burner ignition, operation and burner
flame adjustments.
11. Check appliance for proper operation.
A. Gas supply tubes
B. Screws
C. Bypass screws
Large Dual Burner
A. Burner cap
B. Burner base
Medium Burner
A. Burner cap
B. Burner base
C. Choke (for use with medium
burner, LP gas only)
Small Burner
A. Burner cap
B. Burner base
BC
A
B
B
B
A
B
A
B
C
A
B
Gas
Type
Burner
Rating
(BTU)
Color Size Burner Style
LP
NG
3,000
5,000
Blue
Brass
0.55 mm
1.01 mm
Small burners
LP
NG
11,000
15,000
Brass
Brass
0.92 mm
1.55 mm
Medium burners
LP
NG
14,000
20,000
Brass
Green
Brass
Brass
0.96 mm
0.35 mm
1.80 mm
0.52 mm
Large burner - main
Large burner - simmer
Large burner - main
Large burner - simmer
LP
NG
14,500
18,000
Brass
Brass
1.07 mm
1.77 mm
Grill burner
Gas orifice spud
A. Size stamp or color
A
Loading ...