Loading ...
Loading ...
Loading ...
32
Error code failure system
If your appliance senses that it is not operating correctly, then an error
code may appear in the display window.
The following error codes can possibly be remedied by the customer
and the steps outlined below should be followed.
BEFORE COMPLETING ANY MAINTAINEANCE ON THE
APPLIANCE, IT SHOULD BE DISCONNECTED FROM YOUR MAINS
POWER SUPPLY.
E1
o Longer than expected fill time or drain time.
Check the water pressure of your mains water supply.
Clean the mesh filter that sits in the inlet hose.
Ensure that the inlet hose is not kinked or crushed.
Make sure the water tap that the machine is connected to is turned
on fully.
Check that the outlet hose is not kinked or crushed and that it’s
positioned correctly (as per the installation instructions).
E3
o Longer heating time- not reaching the required temperature.
Malfunction of the temperature sensor or heating element.
Call the Baumatic Customer Care Department.
E4
o The machine has sensed water in the base.
Check that the outlet hose is not kinked or crushed.
Check that there are no blockages in the drain hose or the drainage
system that the appliance is connected to.
The drain pipe may be placed in too high a position or incorrectly.
Check the installation instructions and ensure that the installation is
correct.
E6
o Open circuit
Thermistor
Call the Baumatic Customer Care Department.
E7
o Short circuit
Thermistor
Call the Baumatic Customer Care Department.
Loading ...
Loading ...
Loading ...