Loading ...
Loading ...
Loading ...
15
5. Start-up
•
Remove the packaging.
•
Check the device, mains part and cable for damage.
•
Insert the connector plug into the socket on the massager to charge the device.
•
Charge the device for at least 3 hours before initial operation.
•
When the device starts to charge, an acoustic signal sounds.
During the charging process, the LEDs on the
battery display flash from left to right, depending on the battery state.
•
Once the device is fully charged, all 5 LEDs light up and an acoustic signal sounds 3 times.
•
If the battery is low, the LED display for the on/off mode (green light) starts to flash and an acoustic signal
sounds 3 times. If the battery is flat, the device switches off and an acoustic signal sounds again 3 times.
•
The device can also be operated with a mains part. There is no charging in this case, however.
• Route the cable safely so that there is no risk of anyone tripping over it.
6. Operation
• The tapping massager can be used with or without the handle. It can be used with the handle to massage
hard-to-reach parts of the body such as the shoulder and back area. It can be used without the handle
for a more intensive, stronger massage.
• To remove the handle, please press and hold down the button (3) and at the same time pull the handle
(4) away from the massage head. Then insert the plug-in element (11) in the back of the massage head to
cover the handle attachment mechanism.
• Hold the massage head by the hand knob (9) so that you can guide the massage head securely.
• If you want to reattach the handle (4), first pull out the plug-in element (11) and push the handle (4) back
on until you feel and hear it engage.
• You can use various massage attachments for massaging. To do this, select one of the 4 interchangeable
massage attachments of your choice.
• Screw the attachments onto the massage head in a clockwise direction. To replace or remove the attach-
ments, turn these anti-clockwise.
• Switch on the massager with the on/off button (
).
• When you press the buttons, a short acoustic signal sounds as confirmation. After this, the current bat
-
tery state is displayed for 2 seconds and the massage then starts with the intensity level that was most
recently selected.
• For the warming attachment (5), the application of heat can also be switched on or off by pressing the
button once. Press again to switch off the heat function. The heat function is only available with
the supplied warming attachment (5).
• Use the intensity selection buttons (+/-) to set the massage intensity you want. There are 5 different
massage intensities available. Press the (+) button for a higher intensity. Press the (-) button for a lower
intensity.
• Move the device to the part of the body you want to massage. You may be sitting or standing for this and
you can use the device to massage yourself or another person.
• You can change the massage pressure by pressing the massager firmly or more gently.
• After a maximum usage time of 20 minutes, switch the device off and leave it to cool down.
• The device also has an automatic switch-off time of 20 minutes.
• Keep the device dry.
Note
Do not use the massage device just before going to bed. The massage can also have a stimulating
effect and may cause difficulties in getting off to sleep.
Loading ...
Loading ...
Loading ...