Loading ...
Loading ...
Loading ...
©2012 DJI Innovations. All Rights Reserved. 12 |
B2 Control Mode Switch
1
The transmitter you used must be Fail-Safe featured, which allows you to setup fixed outputs for all channels if the
receiver loses signals, otherwise Ace Waypoint will not enable the Enhanced Fail-Safe. See Page 23 for details.
2
Working mode for your transmitter should be HELICOPTER.
3
All the channels in your transmitter should be working independently: NO CCPM, NO channel MIX，NO EXP.
4
You need at least one 2 or 3-position switch on your transmitter to be set as the control mode switch.
In Assistant Software, page TX-MONITOR:
1
2
3
Once the switch position has been matched to specific control
mode, you will see the high-light as shown following.
TX
Whichever 2 or 3 positions switch/channel user has
selected or decided to use in the transmitter (for control mode
switching), in this case channel U marking on MC. Use sub-trim
or end-point (+/-) fine tuning on your transmitter, move the slider
of channel U to the specific range until Ace Waypoint Assistant
indicates that it is in Manual, GPS Cruise, GPS Atti., Atti. and
Failed-Safe mode.
Notice: To move the slider is to adjust sub-trim or end-points of
the channel selected.
Tx
1 2 3
3 Position
Switch
For 3-positions switch, you should assign:
Position-2 to GPS Atti. Mode or Atti. Mode;
Position-1 to Manual Mode;
Position-3 to GPS Cruise Mode or GPS Atti. Mode;
Or reverse the assignment for Position-1 and Position-3.
For 2-positions switch, you should assign:
Position-1 to Manual Mode;
Position-3 to GPS Cruise Mode or GPS Atti. Mode;
Or reverse the assignment for Position-1 and Position-3.
Notice: Please see page 4 for introduction of autopilot control
modes.
Set Fail-Safe output of receiver to input port-U, move
the slider to the range which reads Fail-Safe MODE.
IMPORTANT: Ace Waypoint would not execute Fail-Safe
protection if you don’t set it properly. You can verify the Fail-Safe
settings by shutting down your transmitter, and then you can use
the following method to check whether Ace Waypoint was
already in Fail-Safe mode.
You can check the current control mode of Ace
Waypoint using either of the following methods:
Check the Ace Waypoint Assistant status bar at the bottom
side of the software interface.
Check the LED indicators status on GPS/Compass module,
see Appendix in this manual for details.
Loading ...
Loading ...
Loading ...