Loading ...
Loading ...
Loading ...
BEFORE YOU BEGIN
Read these instructions completely and carefully.
•
IMPORTANT – Save these
instructions for local inspector’s use.
•
IMPORTANT – Observe all
governing codes and ordinances.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these instructions
for future reference.
• Skill level – Installation of this appliance requires
basic mechanical skills.
• Completion time – Refrigerator Installation
15 minutes.
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is not
covered under the Warranty.
• Do not install the refrigerator where the temperature
will go below 60°F (16°C) because it will not run often
enough to maintain proper temperatures.
• Do not install the refrigerator where the temperature
will go above 100°F (37°C) because it will not perform
properly.
• Install it on a floor strong enough to support it fully
loaded.
REFRIGERATOR LOCATION
If you have questions, call 1.800.GE.CARES or visit our Website at: ge.com
Installation
Refrigerator
Instructions
Models 18 and 19
Allow the following clearances for ease of installation,
proper air circulation and plumbing and electrical
connections.
• Sides 1/8″ (3 mm)
• Top 1″ (25 mm)
• Back 1″ (25 mm)
If the refrigerator is to be installed next to a wall on the
hinge side, allow 5/16″ (8 mm) door clearance.
CLEARANCES
The leveling legs have 2 purposes:
• Leveling legs adjust so the door closes easily when
opened about 45°.
• Leveling legs adjust so the refrigerator is firmly
positioned on the floor and does not wobble.
• Rollers allow you to move the refrigerator away from the
wall for cleaning.
NOTE: When leveling legs are properly adjusted, the top
of the refrigerator will not be level but will have a slight
backward tilt.
Adjust front leveling legs so
that refrigerator is in solid
contact with floor and door
swings closed when partially
opened.
Check door alignment and
gasket seal after adjusting
leveling legs.
LEVELING LEGS
If the refrigerator has an icemaker, it will have to
be connected to a cold water line. A GE water supply
kit (containing tubing, shutoff valve, fittings and
instructions) is available at extra cost from your
dealer or by visiting our Website at ge.com or
Parts and Accessories, 800.626.2002.
WATER SUPPLY TO THE ICEMAKER
(ON SOME MODELS)
13
Clockwise
to Raise
Refrigerator
Loading ...
Loading ...
Loading ...