Loading ...
Loading ...
Loading ...
English
15
Preparation
Setting the clock
After connecting MCM239D to the power
supply, set the clock first.
1 Press and hold STANDBY-ON/ ECO
POWER to switch the set to Standby mode.
➜ The display shows the set time.
➜ -- --:-- -- flashes by default if you have not set
the clock.
2 In the standby mode, press and hold DISPLAY/
CLOCK.
➜ SET CLOCK scrolls on the display
➜ 24 HR or 12 HR appears for the initial
clock setting. To select 24-hour clock or
12-hour clock,
a. Press VOLUME +/- .
b. Press DISPLAY/CLOCK to confirm
➜ The hours digits start flashing
3 Hold down or press VOLUME +/- repeatedly
to set the hours.
4 Press DISPLAY/CLOCK to confirm
➜ The minutes digits start flashing
5 Hold down or press VOLUME +/- repeatedly
to set the minutes.
6 Press DISPLAY/CLOCK to confirm
– To exit without storing the clock setting press
STOP 9
Helpful hints:
– The clock setting will be erased when the system
is disconnected from the power supply.
– The set will exit from the clock setting mode if
no button is pressed within 90 seconds.
–To set the clock automatically by using a time
signal which is broadcast together with the RDS
signal see chapter RDS: Setting the RDS
clock..
Using the remote control
IMPORTANT!
– Remove the
protective plastic tab
before using the
remote control.
– Always point the
remote control directly
towards IR area on the Center or Station
you wish to operate.
Notes for remote control:
– First select the source you wish to
control by pressing one of the source select
keys on the remote control (for example
CD, TUNER).
– Then select the desired function (for
example
ÉÅ
,
í
,
ë
).
To replace the remote controls’
battery
CAUTION!
– Remove the battery if it is exhausted
or will not be used for a long time.
– Batteries contain chemical substances,
so they should be disposed of properly.
1 Push to open the battery tray.
2 Replace a new battery according to the
indicated polarity.
3 Push the battery tray back to close it.
MCM239D_05_Eng 9/8/07, 18:0915
Loading ...
Loading ...
Loading ...