Loading ...
Loading ...
Loading ...
P a g e | 11
MAKING THE ELECTRICAL CONNECTIONS
If the AC adaptor is NOT being used, and it is intended to run the heater from battery power only, then NO special
electrical connections need to be considered. Assure the the AC/DC output plug, at the right end of the heater, is
covered with the rubber plug that is mounted under the jack.
If the AC adaptor IS being used, the battery function becomes secondary and used as back-up. Electrical connections
need to be considered.
An approved, GFI protected, grounded, 110V AC, OUTDOOR outlet box and electrical receptacle must be installed
within 24 in. of the AC/DC output plug located at the right end of the heater. This box must be installed by a qualified
electrician and must be placed in a location that is sheltered from rain. Plug the transformer directly into the electrical
socket. Plug the jack, at the other end of the transformer cord, into the corresponding jack receptacle of the heater.
Secure any loose or dangling wires with tape, wire ties, or insulated wire staples.
An alternate to this connection is to run an outdoor extension cord from the closest GFI protected, 110 V grounded
outlet to a distance of within 24 in. from the right end (jack location) of the heater. This cord and connection must be
sheltered from the rain, and must not be in direct line with either the heat output coming from the front of the heater
OR the exhaust gasses exiting the top of the heater. It is recommended that this cord be secured to the wall (or similar
structure) with either tape, wire ties, or insullated wire staples. This installation is condsidered a TEMPORARY
installation.
WIRELESS WALL SWITCH
Select a location for this switch, but do not mount it at this time. Select a location that it out of reach of children, and is
just LOW enough to be reached by an adult. It is recommended that the wall switch be mounted near the heater (within
10 ft) so the heater can both be SEEN and HEARD during operation of the wall switch. This wall switch mounts on a flat
surface with the mounting screws provided. Double sided tape (not provided) will also work for this step.
BATTERY INSTALLATION
Wireless Wall Switch-This unit uses (2) pre-installed 3V Lithium Batteries CR2032. If batteries were not previously
installed, remove the cover by inserting a small screw driver into one of the slots on the side. Twist the screw driver
slightly to snap open the cover from the body. (do not attampt to remove the small screws at the bottom). Insert the
provided lithium batteries (Posiitive (+) side up), making sure the edge of the battery is inserted UNDER the small
battery retaining clip. If the wall switch will be mounted with the provided screws, then mount into position (while the
cover is still off) at this time. After mounted, snap the cover back onto the wall switch body. See pictures below.
Loading ...
Loading ...
Loading ...