GE - General Electric AVX10AC GE Slide-Aire Room Air Conditioner (10,000 BTUH)

User Manual - Page 9

For AVX10AC.

PDF File Manual, 16 pages, Read Online | Download pdf file

AVX10AC photo
Loading ...
Loading ...
Loading ...
Customer ServiceTroubleshooting Tips
Operating Instructions
Safety Instructions
Installation Instructions
Read completely, then follow step-by-step.
Window Requirements
These instructions are for a horizontal sliding or
a casement window.
The electrical outlet must be within reach of the
power cord.
For installation in an extra high horizontal window
(up to 48²), order RAK162 kit from your dealer.
For installation in a casement window, the
window frame assembly and the side of the
building must be adequate to support the weight
of the air conditioner.
Casement window
(See Casement Window Installation Instructions)
Horizontal sliding window
21²
min.
42²
max.
15
1
/
2
²
min.
1
Prepare the Window and the Support Bracket
Attach the support platform to the sill plate
with 3 type C screws. Loosely attach the support
angle to the bottom of the support platform
using 2 type A screws with washers and nuts.
Attach the leveling bolt and nut.
Place the sill plate against the lower window
track and firmly against the vertical side edge of
the window frame. Attach the sill plate to the
window stool using 2 type B screws.
NOTE: To overcome interference of the support platform with
the window track or storm window, securely attach a 2² wide
shim strip to the window sill. This strip should be as long as
the width of the support platform and flush with the back
edge of the sill. The thickness of the strip should be controlled
by the amount of interference.
Pull the support angle against the outside wall
and tighten the screws on top of the support
platform. Adjust the leveling bolt so the
support platform is level. This will allow the air
conditioner to tilt slightly for proper drainage.
Tighten the nut.
NOTE: DO NOT drill a hole in the bottom of the pan.
The air conditioner is designed to operate with the
bottom of the pan approximately half-full of water.
D
C
B
A
2
9
21
1
/
2
² min.
15
3
/
4
²
min.
17
1
/
2
²
max.
Sill plate
3 type C screws
Vertical side edge
Type A screws
with washers
& nuts
Support platform
Support angle
Leveling bolt and nut
Loading ...
Loading ...
Loading ...