Loading ...
Loading ...
3
Care & Maintenance
• Care & Maintenance for the Waterfall Fountain
• It is recommended that your water fountain be left running
continuously and shut down for cleaning when cleaning the
mirrored glass. Use a standard glass cleaner on all surfaces of
the waterfall fountain.
• It is recommended that you drain & clean your water fountain
once very three to four months. After draining, wipe the inside
of the reservoir with a wet rag. It is not necessary to use any
cleaning agents to remove dirt and debris from the reservoir. If
you use soap and/or cleaning solutions make sure to rinse
thoroughly before refilling it clean water. If not properly rinsed,
this could cause foaming with soap residue.
• The waterfall fountain will continuously lose water due to
evaporation. The rate of evaporation is dependent on many
variables such as the climate, humidity & temperature. IT IS
IMPERATIVE THAT THE WATER LEVEL IS MAINTAINED AT
ALL TIMES. You should periodically for the first few months,
monitor the water in the reservoir to determine the rate of
evaporation of this waterfall fountain. If the pump runs dry or
very low, you may cause the pump to burn out thus voiding the
warranty. Residue may also spray onto the waterfall surface
and the this may cause the delivery system to fail.
• Over a period of time, if the water in your area is hard it may
cause the glass & surface to develop a hazy and/or cloudy film.
Adding a water softener to the reservoir may help to control
hard water stains. If the surface develops hard water stains, it
is very easily removed. When the glass is completely dry, take
a damp cloth and wipe or buff the surface in a circular pattern
to remove all stains.
• If the unit develops an algae problem, you will want to access
the reservoir by removing the metal decorative rock & light tray.
Algae is easily detected by a sour odor and/or a gel like
substance. If this occurs then add an algaecide to the unit as
directed.
• If white particles should build up on the glass it is most likely
calcium deposits, which is prevalent in your local water supply
system. This may me removed with a Calcium Lime Remover.
You may also use a scraper and/or razor blade to remove the
calcium deposits. To reduce the maintenance on your waterfall
fountain, use distilled water.
Note: A glass cleaner is recommended to maintain & upkeep the mirrored glass
surface.
Assembling & Using Your Product Cont’d
• Remove all the parts from the shipping cartons
• Lean the glass upright against a wall until you further instructed.
• Remove all the packaging material and parts from the base, which
includes the decorative rocks, metal trays, towel & light kit. Make sure
to leave the pump assembly kit in the base.
• Thread and feed the pump cord through the opening provided in the
reservoir. Pull the pump cord through the opening leaving
approximately 12 inches of the cord inside the reservoir. DO NOT plug
the pump into your local power supply.
• Take the mirrored glass panel with two people; slide the mirrored glass
panel into the center of the base. Place a piece of cardboard over the
base to prevent it from scratching. It is important to place the panel in
the reservoir to the side with the plumbing coming out of the bottom
Loading ...
Loading ...
Loading ...