Loading ...
Loading ...
Loading ...
Operating Instructions
Safety Instructions
Installation
Instructions
Troubleshooting Tips
Consumer Support
28
Care and cleaning of the range.
Burner Caps and Heads
Before removing the burner caps and heads,
remember their size and location. Replace them in
the same location after cleaning.
NOTE: Do not use steel wool or scouring powders
to clean the burner parts.
Burner caps
Lift off when cool. Wash burner caps in hot, soapy
water and rinse with clean water. You may scour
with a plastic scouring pad to remove burned-on
food particles.
Burner Heads and Oval (Center) Burner
Head/Cap Assembly
(on some models)
The burner heads and the oval burner head/cap
assembly are removable. Simply lift them off the
range for cleaning.
For proper ignition, make sure the small hole
in the section that fits over the electrode is kept
open. A sewing needle or wire twist-tie works
well to unclog it.
The slits in the burner heads must be kept clean at
all times for an even, unhampered flame.
Clogged or dirty burner ports or electrodes will not
allow the burner to operate properly.
Any spill on or around an electrode must be
carefully cleaned. Take care to not hit an electrode
with anything hard or it could be damaged.
Clean the burner heads routinely, especially after
bad spillovers, which could clog the openings. Lift
off when cool.
To remove burned-on food, soak the burner heads
in a solution of mild liquid detergent and hot water
for 20–30 minutes. For more stubborn stains, use a
toothbrush.
After cleaning
Before putting the burner caps, heads (on some
models) and oval head/cap assembly back, shake
out excess water and then dry them thoroughly
by setting in a warm oven for 30 minutes.
Replacement
Replace burner heads over the electrodes on
the cooktop, and then replace the burner caps
onto the burner heads, in the correct locations
according to their size.
On models so equipped:
On models so equipped:
Make sure that the heads and caps are replaced
in the correct locations
.
The oval burner head/cap assembly is
removable. Simply lift it off the range for
cleaning. Use a sewing needle or twist-tie
to unclog the small hole in the burner
heads.
Burner cap is
properly seated.
Burner cap is NOT
properly seated.
Slot
Electrode
The burner heads are removable. Simply lift
them off the range for cleaning.
Burner heads (on some models)
Hole in
burner
head
Oval burner head/cap assembly
(on some models)
Medium burner
head and cap
Front of range
Large burner
head and cap
Small burner
head and cap
Extra large
burner head
and cap
Oval head and cap assembly
Slot
Electrode
Slot
Medium burner
head and cap
Front of range
Medium burner
head and cap
Small burner
head and cap
Large burner
head and cap
Make sure the slot in the burner head is positioned over the electrode.
Loading ...
Loading ...
Loading ...