Loading ...
Loading ...
Loading ...
PROBLEM POSSIBLE CAUSE
SOLUTION
W
ater drips from the
holes in the soleplate.
The iron drips
when you start ironing.
T
he chosen temperature is too
low and does not allow for the
formation of steam.
You are using steam while the
i
ron is not hot enough.
You are using the Shot of Steam
button too often.
There is too much steam.
You have stored the iron horizon-
tally, without emptying it and
without setting it to
.
You have removed the anti-scale
rod to fill your iron.
P
osition the thermostat in the steam range
(from •• to MAX).
Wait until the thermostat light goes out.
Wait a few seconds between each use of
the button.
Reduce the steam.
See the section "Storing your iron".
Do not extract the anticalc valve when fil-
ling the iron.
Brown streaks come
through the holes in
the soleplate and stain
the linen.
You are using chemical descaling
agents.
You are not using the right type
of water.
Fabric fibres have accumulated in
the holes of the soleplate and are
burning.
Your linen has not been rinsed
sufficiently or you have ironed a
new garment before washing it.
Do not add any descaling agents to the
water in the water tank.
Perform a self-cleaning operation and
consult the chapter "What water should I
use?".
Perform the self-cleaning operation and
clean the soleplate with a damp sponge.
Vacuum the holes of the soleplate from
time to time.
Make sure that your laundry is rinsed
sufficiently so as to remove any deposits of
soap or chemical products on new clothes.
The soleplate is dirty or
brown and can stain
the linen.
Your are ironing with an inappro-
priate program (temperature too
high).
You are using starch.
Clean the soleplate as indicated above.
Select the appropriate program.
Clean the soleplate as indicated above.
Always spray starch onto the reverse side of
the fabric to be ironed.
There is little or no
steam.
The water tank is empty.
The anti-calc valve is dirty.
Your iron has a build-up of scale.
Your iron has been used dry for
too long.
Fill it.
Clean the anti-calc valve.
Clean the anti-calc valve and carry out a
self-clean.
Carry out a self-clean.
The soleplate is scrat-
ched or damaged.
You have placed your iron flat on
a metallic rest-plate or ironed
over a zip.
Always set your iron on its heel.
Do not iron over zips.
Steam or water come
from the iron as you
finish filling the tank.
The steam control is not set to
the position.
The water tank is overfilled.
Check that the steam control is set to the
position.
Never exceeed the Max level.
The spray does not
spray.
The water tank is not filled
enough.
Fill up th water tank.
If there is a problem?
If you have any problem or queries, please contact our Customer
Relations team first for expert help and advice.
17
EN
1800125880 FV3756 U0 T-FAL_110x154 TF 27/03/12 16:08 Page17
Loading ...
Loading ...
Loading ...