Loading ...
Loading ...
Loading ...
Part Number:040005890 Rev 05 12/19 9
Location of Ice Machine
The location selected for the ice machine must meet the
following criteria. If any of these criteria are not met, select
another location.
• The location must be indoors.
• The location must be free of airborne and other
contaminants.
• The air temperature must be at least 40°F (4°C), but must
not exceed 110°F (43°C).
• The location must not be near heat-generating
equipment or in direct sunlight.
• The location must be capable of supporting the weight of
the ice machine and a full bin of ice.
• The location must allow enough clearance for water,
drain and electrical connections in the rear of the ice
machine.
• The location must not obstruct airflow through or
around the ice machine (condenser airflow is in and
out the front). Refer to the chart below for clearance
requirements.
• The location must not be near garbage or other
contaminants.
• The ice machine must use legs or be sealed to the floor.
Before sealing to the floor, the rubber bumpers on the
bottom of the ice machine must be removed.
Location
Self-Contained Air-
Cooled
Self-Contained
Water-Cooled
Top/Sides 5 (127 mm) 5 (127 mm)
Back 5 (127 mm) 5 (127 mm)
The ice machine may be built into a cabinet. There is no
minimum clearance requirement for the top or left and right
sides of the ice machine. The listed values are recommended
for efficient operation and servicing only.
Series Ice Machine Heat of Rejection*
Ice Machine Air Conditioning** Peak
U140 2400 2900
U190 2200 2600
U240 2800 3300
U310 3800 6000
* B.T.U./Hour
** Because the heat of rejection varies during the ice making
cycle, the figure shown is an average.
Ice machines, like other refrigeration equipment, reject heat
through the condenser. It is helpful to know the amount of
heat rejected by the ice machine when sizing air conditioning
equipment where self-contained air-cooled ice machines are
installed.
LEVELING THE ICE MACHINE
1. Screw the leveling legs onto the bottom of the ice
machine.
2. Screw the foot of each leg in as far as possible.
3. Move the ice machine into its final position.
4. Level the ice machine by using a level on top of the ice
machine. Turn each foot as necessary to level the ice
machine from front to back and side to side.
Section 2
Installation
Loading ...
Loading ...
Loading ...