Loading ...
Loading ...
Loading ...
16 English
Unit is not plugged in. Plug power cord into electrical outlet.
Household circuit breaker/ground fault circuit interrupter has tripped or blown fuse. Reset circuit breaker/ground
fault circuit interrupter, or replace fuse. For assistance, contact licensed electrician.
Ensure power head is securely in place for proper power connection.
Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance.
This is normal. Water is being dispensed into Base.
Water level in Tank is empty or too low. Refill with clean, cool tap water. See HOW TO USE for instructions.
Unit has reached its set point. When set humidity level is reached, the Fan will turn off until humidity level in
room drops below humidity set point.
Airflow is blocked. Remove obstruction.
Unit settings are too low. Set to High Fan Speed and Continuous Humidity for maximum humidity output.
The additional sodium in chemically softened water may cause Wicks to harden. Try using untreated tap water or
distilled water.
Try adding Bacteriostat or Water Treatment, found at most hardware or home specialty stores to the water.
Or periodically remove the Wicks and clean by soaking them in solution of 1 teaspoon chlorine bleach and 1
gallon water. Let stand 20 minutes. Rinse thoroughly in cool water. Allow excess water to run off and dry before
replacing Wick in Base. DO NOT wring.
Unit fails to power on.
Unit makes bubbling
or gurgling sound.
Unit is not producing
desired amount
of humidity.
Wicks are in need
of replacement
too often.
TROUBLESHOOTING
POSSIBLE CAUSE AND SOLUTIONPROBLEM
Loading ...
Loading ...