Loading ...
Loading ...
Loading ...
5
Electrical Requirments
-Check your national and local codes regarding this unit.
-Use 120V/15 amp power cord included with the unit.
Electrical Connection
WARNING
ELECTRICAL SHOCK HAZARD
This appliance is equipped with a 3-prong power cord with
a grounding plug for your protection against shock hazard
and should be plugged directly into a properly grounded
receptacle. Do not cut or remove the grounding prong from
this plug. Unit must be grounded in accordance with local
codes or with the National Electrical Code ANSI/NFPA 70, or the
Canadian Electrical Code, CSA C22.
General Information
• When installing this unit directly below other units, only install with Viking Range, LLC built-in products.
•Remove warming drawer carefully from carton. Remove all loose packaging and accessories.
• It is the responsibility of the installer to comply with local codes. If no local codes are applicable, wire in accordance
with the National Electrical Code, ANSI/NFPA-70 – latest edition.
• Line disconnect switch, circuit breaker, GFI (for outdoor models) or plug/ receptacle of power cord connection should be readily
accessible to the operator.
•Ground unit per applicable electrical codes.
•Any installation not matching the speci cations discussed in these instructions will void the manufacturer’s warranty.
READ AND FOLLOW ALL WARNING AND CAUTION INFORMATION WHEN INSTALLING THIS APPLIANCE.
Moving, Handling and Unpacking
Remove and discard all packing materials, including cardboard and tape on the outside and inside of the warming drawer.
Some stainless steel parts may have a plastic protective wrap which must be peeled o . The interior should be washed thoroughly
with hot, soapy water to remove lm residues and any dust or debris before being used, then rinsed and wiped dry. Solutions
stronger than soap and water are rarely needed.
Loading ...
Loading ...
Loading ...