Loading ...
Loading ...
Loading ...
en Troubleshooting
46
Fault Cause Troubleshooting
Excessive formation of foam
occurs.
Detergent or appliance care
product used causes excess-
ive foaming.
▶
Change the brand of detergent.
Information on display panel
Fault Cause Troubleshooting
Special salt refill indicator
lights up.
Insufficient special salt.
▶
Add "Special salt" →Page23.
Sensor does not detect spe-
cial salt tablets.
▶
Do not use special salt tablets.
Refill indicator for special
salt does not light up.
Water softening system is
switched off.
▶
Setting the water softening system
Refill indicator for rinse aid
lights up.
Insufficient rinse aid. 1. Add "Rinse aid" →Page25.
2. Set the amount of rinse aid to be
dispensed.
→"Setting the amount of rinse aid",
Page25
Refill indicator for rinse aid
does not light up.
Rinse aid system is switched
off.
▶
Set the amount of rinse aid to be
dispensed.
Malfunctions
Fault Cause Troubleshooting
Water is left in the appliance
at the end of the pro-
gramme.
Filter system or area under
the filters is blocked.
1. Clean the "Filters" →Page36.
2. Clean the "Wastewater pump"
→Page49.
Programme has not yet
ended.
▶
Wait until the programme ends or
cancel the programme with Reset.
▶
→"Terminate programme",
Page32
Appliance cannot be
switched on or operated.
Appliance functions have
failed.
1. Pull out the mains plug or switch off
the fuse.
2. Wait at least 2minutes.
3. Connect the appliance to the power
supply.
4. Switch the appliance on.
Appliance does not start. The mains fuse has tripped.
▶
Check the relevant fuse.
Mains cable is not inserted. 1. Check whether the socket works.
2. Check whether the mains cable is
properly inserted in the socket and
on the rear of the appliance.
Loading ...
Loading ...
Loading ...