Loading ...
Loading ...
Loading ...
7
MODEL: RJ11-17-GPT
HOW TO USE
1. Remove all packing materials. Rinse the inside of the Kettle and tea infuser with water.
Dry outside of Kettle thoroughly.
2. Place the Kettle’s base on a flat, sturdy surface away from all water and heat sources.
Plug cord into outlet.
3. Remove Kettle from base if attached. Push lid release button to raise lid. Fill with desired
amount of water. Do not exceed the MAX fill line (1.7 L) and do not fill below the MIN fill
line (0.6 L).
NOTE: Only use the Kettle to heat water and tea.
4. Push lid down to close and snap into place. Ensure that the lid is flush with the top of the Kettle.
5. Place the Kettle onto the base.
6. The Kettle may be started several ways:
a. Quick Start/Boil Water
i. Press the PLAY button to start the Kettle. Once PLAY is selected, it will illuminate
in red, indicating that the heater is on. The temperature on the screen will switch to
the live temperature of the water. The blue light around the base of the Kettle will
also illuminate.
Once the Kettle reaches the set temperature (in this case, 212°F, which is the
Kettle’s default,) the Kettle will beep once and the PLAY button will change from
red to orange, indicating that the Kettle is keeping warm.
During this time, the screen will display the live temperature of the water.
The Kettle will keep warm for 60 minutes.
b. Set the temperature before pressing PLAY*: (MIN temp = 105°F, MAX temp = 212°F)
i. Press the TEMP Button. It will flash in blue. Immediately use the - and + buttons to
select desired temperature. Press the TEMP button again to set the temperature
OR temperature will automatically set in 5 seconds. TEMP button will stop flashing
to indicate temperature has been set.
ii. Press PLAY to start Kettle, OR set steep time. Set steep time by following how to
steep directions on page 08.
*Temperature may be set at any time during the default mode (see page 6 for Default Mode
definition). It cannot be set once the Kettle is heating or during the keep warm function.
Temperature may be reset at any time by pressing the PLAY button to cancel and return to
default mode.
Operating Instructions
Loading ...
Loading ...
Loading ...