Loading ...
Loading ...
Turbo fan(selected models)
The turbo fan is used
to boost the airflow
around the room. This
circulates the heat
better and results in a
reduced heat up time
and a more even heat
distribution. The turbo
fan is controlled by the
neon switch on the front
of the product.
The turbo can be turned
on independently of the
heat, however the fan
will switch on and off
under the control of the
thermostat.
Note: On selected models in warm weather the fan
can be used to circulate cool air. Once the heat
selection switches are in the off position and the
thermostat is set to ‘Max’ the fan will continue to
function to circulate cool air.
Safety – overheat protection
For your safety, this appliance is tted with a thermal
cut-out. In the event that the product overheats, the
cut-out switches the heater off automatically.
To bring the heater back into operation, remove the
cause of the overheating, then unplug or turn off
the electrical supply to the heater for a few minutes.
When the heater has cooled sufciently, re-connect
and switch on the heater.
Important Notes
Although this heater is manufactured to comply with
the relevant safety standards, certain types of carpets
could become discoloured by the temperatures
under a portable heater. If you are concerned about
this, we recommend that you contact the carpet
manufacturer for guidance. Alternatively, stand the
heater on a suitable base to shield the carpet or
wall-mount it – call our Helpline for further advice.
You may notice some parts of the element appearing
to be hotter from time to time because of the variable
airow through the heater. This does not cause a
safety hazard.
The heat outlet grille may become discoloured with
use – this is caused by airborne pollution and is not
a fault.
Recycling
Do not dispose of electrical appliances as
unsorted municipal waste. Use separate
collection facilities. Contact your local
government for information regarding the
collection systems available. If electrical
appliances are disposed of in landlls or dumps,
hazardous substances can leak into the ground
water, polluting the food chain and damaging health
and well-being.
Cleaning
WARNING – ALWAYS DISCONNECT FROM
THE POWER SUPPLY BEFORE CLEANING
THE HEATER.
Before commencing cleaning, switch off the heater
and allow it to cool. Disconnect the electricity
supply to the appliance.
The outside can be cleaned by wiping it over
with a soft damp cloth and then dried. Do not use
abrasive cleaning powders or furniture polish, as
this can damage the surface nish.
After Sales Service
Please refer to the warranty card in the box for
warranty information. For any troubleshooting advice,
please contact the relative Customer Care Centre
below.
Glen Dimplex Australia Pty Ltd
1340 Ferntree Gully Road,
Scoresby 3179, Victoria
Australia
Ph: 1300 556 816
Glen Dimplex New Zealand Ltd
38 Harris Road, East Tamaki,
Auckland 2013
New Zealand
Ph: 0800 666 2824
Fig. 4
Loading ...