Loading ...
Loading ...
Loading ...
Red inlet valve
Blue inlet valve
Cold fill
Y-piece
Fig.2
Hot fill
Red inlet valve
Blue inlet valve
Cold fill
FILL INSTRUCTION
For Models with Dual Inlets
10
1. Fix the red marked inlet hose to the hot water tap and to the inlet valve with the red
filter on the rear side of machine.
2. Fix the
other inlet hose to the cold water tap and to the inlet valve with the blue filter
on the rear side of the machine.
Make sure:
a) The connections are tightly fixed
b) Do not invert their position (for example: cold fill into hot
inlet valve and vice versa).
If you wish to connect only the cold fill follow the below instructions (Fig. 2):
1. You need a Y-piece connector. This can be purchased from local hardware or
plumbing supplier.
2. Fix the
Y-piece connector to the cold fill tap.
3. Connect the two inlet valves present on the rear part of the machine to the Y-piece
connector using the hoses provided.
Note that during the wash cycles, the surface temperature of the porthole door
may increase.
Close supervision of children is necessary when the appliance is used near
children.
If you wish to connect hot and cold water supply (Fig.1):
All connections are tightly fixed.
Do not allow children to operate, crawl on, be near or inside your washer.
For Models with Single Inlet
Fix the inlet hose to the cold water tap and to the inlet valve on the rear side of the
machine as Fig. 3
Inlet valve
Cold fill
Fig.1 Fig.3
Ensure that:
Loading ...
Loading ...
Loading ...