Loading ...
Loading ...
Loading ...
Problem Cause Solution
The shot-of-
steam function
does not work
(all types except
GC2510).
You have used
the shot-of-steam
function too often
within a very short
period.
Continue ironing in horizontal
position and wait a while before
you use the shot-of-steam
function again.
The iron is not hot
enough.
Set an ironing temperature that
is suitable for steam ironing
( 2 to MAX). Put the iron
on its heel and wait until the
temperature light goes out
before you start ironing.
Flakes and
impurities come
out of the
soleplate during
ironing.
Hard water forms
akes inside the
soleplate.
Use the Calc-Clean function
one or more times (see chapter
‘Cleaning and maintenance’,
section ‘Calc-Clean function’).
The light on the
handle ashes
(GC2560 only).
The automatic
shut-off function
has been activated
(see chapter
‘Features’, section
‘Automatic shut-
off’).
Pick the iron up or move
it slightly to deactivate the
automatic shut-off function. The
automatic shut-off light goes out.
There are water
droplets on the
fabric.
You have not
closed the cap of
the lling opening
properly.
Press the cap until you hear a
click.
There are water
droplets on the
fabric (GC2640/
C2620/GC2530/
GC2528/
GC2520/
GC2510 only).
The set
temperature is
too low for steam
ironing.
Set an ironing temperature that
is suitable for steam ironing
( 2 to MAX). Put the iron
on its heel and wait until the
temperature light goes out
before you start ironing.
Water drips
from the
soleplate after
the iron has
cooled down or
has been stored
(GC2640/
C2620/GC2530/
GC2528/
GC2520/
GC2510 only).
You have put the
iron in horizontal
position while there
was still water in
the water tank.
Empty the water tank and set
the steam control to position
O after use. Store the iron on
its heel.
4
4239.000.6144.8
Loading ...
Loading ...
Loading ...