Loading ...
Loading ...
Loading ...
1110
Grille Assembly -
Custom Panel Models
On Custom Panel models, grill spacers from original unit grilles must be reused:
• Remove grille brackets from grille included in the grille kit by removing 4 screws on each
grille bracket located on the back of the grille assembly.
• Remove grille brackets and spacers from original unit grilles by removing 4 screws on each
grille bracket located on the back of each grille assembly.
• Install grille brackets and spacers from original unit grilles onto grille from the kit using the
original grille hardware.
Important: The spacers must be oriented on the new grille the
same way they were on the original grille.
Also, remember to install the spacers on the
corresponding side of the installation (if installing a unit on the left side of an installation, its
grille spacers should be installed on the left side of the unified grille.)
Grille Assembly Bracket Placement -
Custom Panel Models
For 66” grille, excluding Custom Panel, Add/Remove brackets to full length grille as required.
See illustration below.
TOP
Use this bracket if 36” W. product is
on right side (facing unit), otherwise
remove.
Use this bracket if 30” W. product is
on left side (facing unit), otherwise
remove.
Use this bracket if 30” W. product is
on right side (facing unit), otherwise
remove.
Use this bracket if 36” W. product is
on left side (facing unit), otherwise
remove.
*NOTE: Depending on unit configuration, two brackets should be removed and discarded. The
72” W. and 60” W. grille assemblies have all four (4) brackets mounted in the proper location.
66” Custom Grille (back view)
Loading ...
Loading ...