Loading ...
Loading ...
Loading ...
en Operating the appliance
30
Remaining running time
display
When the programme is selected, the
remaining programme time is indicated
in the display window )".
The running time is determined during
the programme by the water
temperature, the quantity of dishes as
well as the degree of soiling and may
vary (depending on the selected
programme).
Programme turboSpeed 20 min:
During the heating up phase the display
window shows the symbol • alternating
with the remaining running time. At the
end the symbol p flashes, to indicate
that the dishwasher can be opened and
loaded. Once the appliance has been
restarted, the remaining running time
will again be displayed during the
washing phase.
Time preselection *
Ti me pr es el ect i on
* depending on the configuration of
your specific dishwasher
You can delay the start of the
programme in hourly steps by up to 24
hours.
Here’s how to set up the delay:
1. Switch on ON/OFF switch (.
2. Press the timer programming button
@ + repeatedly until )" œ ‹‚
appears in the display window.
3. Keep pressing the timer
programming button @ - or + until
the desired time is displayed.
4. Press START button P.
The delay timer has been activated.
5. To clear the specified delay, press
the button @ - or + repeatedly until
)" œ ‹‹ appears in the display
window.
Until the programme has started, you
can change your selection in any way
you like.
Programme end
The programme has finished when the
value ‹:‹‹ appears in the display
window )".
The following applies to turboSpeed
20 min:
When ‹:‹‹ appears in the display
window )" this indicates that the wash
cycle has finished. When you open the
dishwasher door the symbol p will
appear in the display window. If no
further wash cycles are required, switch
off the dishwasher with the ON/OFF
switch (.
Loading ...
Loading ...
Loading ...