Loading ...
Loading ...
Loading ...
3.
LIMITED WARRANTY
How to Obtain Warranty Service
Contact Wet Sounds, Inc. either by phone at 877-938-7757 or by email at
[email protected]. A service representative will assist you in the
necessary actions to verify that the problem that you are experiencing is covered
under warranty. If it is in fact a warranty issue, Wet Sounds will issue an RA
number for tracking purposes and give instructions on sending the product in for
evaluation. Wet Sounds™, Inc. How State Law Applies This warranty gives you
specic legal rights, and you may also have other rights which vary from
state to state.
Internet Warning
Wet Sounds, Inc. products sold on any non authorized web site or internet
auction site are void of any and all manufacturer’s warranty. Please contact
Wet Sounds™ at 877-938- 7757 or visit our web site at www.wetsounds.com to
search for an authorized site and/or an authorized retailer near you.
Caution & Respect
Wet Sounds™ speakers can achieve very high sound pressure levels. Please
use this product responsibly. Be aware that sound travels great distances so
please respect others. Wet Sounds, Inc. is not responsible for any violations of
the law that may be a direct result of excessive volume. Please abide by the rules
but have fun doing it.
INSTALLATION
A. Instructions
1. Fit the appropriate tube clamp around the front strut in the desired location.
*Note: you may need to remove bolts connecting the top to the front
strut to complete this step.
2. If a sliding adapter was supplied in your kit, you will need to loosely fasten it to
the soundbar, and then to the round tube clamps installed in step 1.
3. Ensure that the sound bar is in the desired location, then tighten all hardware.
B. Wiring
STEALTH 10 & 6 CORE Sound Bars are designed to be connected to a
source unit or amplier.
1. Mount & wire the power amp/source unit according to the manufacturer’s
specications.
2. Run the appropriate sized speaker wire (suggested minimum 18 Gauge) to the
sound bar.
Wiring Color Codes for both units are as follows:
Red w/ White Stripe: Right + (positive) Speaker Connection
Black w/ White Stripe: Right – (negative) Speaker Connection
Solid Red: Left + (positive) Speaker Connection
Solid Black: Left – (negative) Speaker Connection
3. Tie up all excess wires.
Loading ...
Loading ...
Loading ...