Loading ...
Loading ...
Loading ...
Use reverse procedures to put accessories back in place.
How to remove and clean accessories.
Dust
If the door seal strip
gets dirty, it can be
easily damaged and
can cause cold air to
escape.
Lift upwards holding right and
left sides and (the piece is
attached quite firmly).
Then draw forwards to remove.
Make sure that that it is put
back on properly. (If these accessories are not put
back properly, they may fall off and cause injury.)
Door seal strip
The door seal strip
Free Pockets/Bottle Pockets/Small Items Pocket
Warning
If dust collects on the electrical
plug or cord,
it can get damaged and can cause a fire.
Unplug the electrical plug from the outlet and inspect.
Is there any damage or abnormal heat coming from the plug or cord?
Wipe away dust from the plug and around the plug area with a dry cloth.
Insert the electrical plug fully into the outlet.
Inspect your electrical plug and cord
After cleaning accessories, inspect at regular intervals
What to do in these situations
When there is a power failure:
Minimize opening/closing of doors and avoid putting in more food.
When not in use for a long time:
Clean the interior after unplugging the refrigerator, and keep the door open for 2 - 3 days to let it dry.
If not allowed to dry properly, mold and odors can occur, or refrigerant (gas)
may leak due to corrosion of the cooling unit.
When transporting:
When moving the unit / when changing the direction of the unit:
1. Discard the water/ice from the Ice cube box and the Ice tray.
2. Use protective gear (protective gloves).
3. Lay towels under the water discharge outlet and under the back corners of the
refrigerator, and place a container or tray on the floor that’s about 3 cm high to catch water.
1.
Lift the adjustable legs.
2.
Move in a forward or backward direction. If moved other than in a forward or backward direction, there’s a risk of damaging the floor.
3. When changing the direction of the unit, please use caster wheels or place a protective cloth under the back legs.
Do not damage the refrigerant circuit, do not drive in screws, etc.
The unit uses a flammable refrigerant, so if the gas leaks out, there is the risk of ignition or an explosion.
4. Slowly tilt the refrigerator back to an angle of over 30 degrees, discharge water of the Evaporator
Tray through the water discharge outlet (the Evaporator Tray is not visible from the outside.)
5. With more than two persons, calmly and slowly transport the unit by grasping the
front side’s lower section inner edge and the back side’s upper section handle.
Towels prevent water from spilling on the floor and damage to the floor.
Have two or more persons do this work because the unit is heavy.
Avoid having young children or those without confidence do this work.
Please seek advice from a moving company.
Do not lay or load on its side (it will cause damage to the compressor.)
If you are moving, it will not be necessary to convert the electrical power frequency.
(Can use 50 or 60Hz).
Water discharge outlet
Page 4
Front side - lower
section inner edge
Back side - upper
section handle
Warning
In the event that the LED light is damaged
or malfunctions, please refrain from
adjusting or repairing it by yourself.
Please contact the service center instead.
How to Replace the LED Light
Page 7
Loading ...
Loading ...
Loading ...