TT-360 OWNER'S MANUAL

Loading ...

©IMPEX INC. www.marcypro.com

CONSUMER INFORMATION SHEET FOR

PLAYGROUND SURFACING MATERIALS

The U.S. Consumer Product Safety Commission (CPSC) estimates that about 100,000 playground equipment-

related injuries resulting from falls to the ground surface are treated annually in U.S. hospital emergency rooms. Injuries

involving this hazard pattern tend to be among the most serious of all playground injuries, and have the potential to be

fatal, particularly when the injury is to the head. The surface under and around playground equipment can be a major

factor in determining the injury-causing potential of a fall. It is self evident that a fall onto a shock absorbing surface is less

likely to cause a serious injury than a fall onto a hard surface. Playground equipment should never be placed on hard

surfaces such as concrete or asphalt and while grass may appear to be acceptable it may quickly turn to hard packed

earth in areas of high traffic. Shredded bark mulch, wood chips, fine sand or fine gravel are considered to be acceptable

shock absorbing surfaces when installed and maintained at a sufficient depth under and around playground equipment.

The following table lists the maximum height from which a child would not be expected to sustain a life-threatening

head injury in a fall onto four different loose-fill surfacing materials if they are installed and maintained at depths of 6, 9,

and 12 inches. However, it should be recognized that all injuries due to falls cannot be prevented no matter what

surfacing material is used.

FALL HEIGHT IN FEET FROM WHICH A LIFE THREATENING HEAD INJURY

WOULD NOT BE EXPECTED

TYPE OF MATERIAL

6-INCH DEPTH

9-INCH DEPTH

12-INCH DEPTH

Double Shredded Bark

Mulch

6 10 11

Wood Chips

. .

6 7 12

Fine Sand

5 5 9

Fine Gravel

6 7 10

It is recommended that a shock absorbing material should extend a minimum of 6 feet in all directions from the

perimeter of stationary equipment such as climbers and slides. However, because children may deliberately jump from a

moving swing, the shock absorbing material should extend in the front and rear of a swing a minimum distance of 2 times

the height of the pivot point measured from a point directly beneath the pivot on the supporting structure.

This information is intended to assist in comparing the relative shock-absorbing properties of various material. No

particular material is recommended over another. However, every material is only effective when properly maintained.

Materials should be checked periodically and replenished to maintain correct depth as determined necessary for your

equipment. The choice of a material depends on the type and height of the playground equipment, the availability of the

material in your area, and its cost.

'This information has been extracted from the CPSC publications "Playground Surfacing - Technical Information Guide" and

"Handbook for Public Playground Safety:' Copies of these reports can be obtained by sending a postcard to the: Office of Public Affairs,

U.S. Consumer Product Safety Commission, Washington, D.C., 20207 or call the toll-free hot line: 1-800-638-2772.

Loading ...

OWNER'S MANUAL - Page 4