Loading ...
Loading ...
Loading ...
10 / EN
1 /E N2N96E N038_3.
To change the cord:
1. Make sure that the dryer is not plugged into
any power outlet.
B
DO NOT plug end of dryer power
cord into a live receptacle before
connecting dryer power cord
to dryer terminals and closing
junction/splitter box as described
below.
B
DO NOT repair old power supply
cords. Power cord must be
changed only by a qualified
person. There is a risk of electric
shock!
2. Remove the screw from the cover of the
junction box located at the top rear of the
dryer.
3. Remove the red, white and black wire from
the terminal block.
4. Remove the green ground wire from the
ground terminal.
5. Loosen the strain relief clamp holding the
4-wire cable.
6. Thread the 4-wire cable out through the
strain relief clamp.
7. Thread the new 3-wire dryer cord through
the strain relief clamp.
8. Attach the power cord Ground conductor
(the center wire) to the terminal labeled N.
Connect the terminal labeled N and the
Ground terminal labeled G with the supplied
short cable. Tighten the terminals so that they
securely hold the conductors.
9. Attach the two remaining power cord
outer conductors to the 2 terminals labeled
L. Tighten both screws so that the power
conductors are securely held in place.
10. Tighten the strain relief so that the power
cord cannot be moved.
11. Replace the cover on the junction box and
fasten in place.
Power Cable
The dryer is now ready to be plugged into the
3-wire receptacle of the proper rating.
The receptacle should be located so that the
plug and receptacle will be accessible with the
dryer in its installed position.
3.2 Grounding Instructions
This appliance must be grounded. In the event
of malfunction or breakdown, grounding will
reduce the risk of electric shock by providing
a path of least resistance for electric current.
This appliance is equipped with a cord having
an equipment-grounding conductor and a
grounding plug. The plug must be plugged
into an appropriate outlet that is properly
installed and grounded in accordance with all
local codes and ordinances.
• Power cord plug must be within easy reach
after installation.
• The voltage and the allowed fuse/breaker
protection are specified in the section
“Technical Specifications”.
• The stated voltage must match your mains
voltage.
• Connection via extension cords or multi-
plugs should not be made.
• The main fuse/breaker and switches must
have a contact distance of minimum 3 mm.
B
A damaged power cable must be
replaced by a qualified electrician.
B
WARNING – Improper connection
of the equipment-grounding
conductor can result in a risk
of electric shock. Check with a
qualified electrician or service
representative or personnel if you
are in doubt as to whether the
appliance is properly grounded.
Do not modify the plug provided
with the appliance: if it will not fit
the outlet, have a proper outlet
installed by a qualified electrician.
B
The appliance must not be
operated unless it is repaired!
There is the risk of electric shock!
Loading ...
Loading ...
Loading ...