Loading ...
Loading ...
Loading ...
262 SERVICING AND MAINTENANCE
7. Reinstall the access cap making sure it is
seated into the housing and turn cap
clockwise to engage locking lugs. Visually,
you should be unable to see the blue O-ring
gasket. The access cap should be uniformly
seated and you should not be able to pull
the access cap off without turning it
counterclockwise.
Front Turn Signal Lamps
See steps below to replace:
1. Open the hood.
NOTE:
Removal of the air cleaner filter housing may be
necessary prior to replacing bulbs in the head-
lamp assembly on the driver side of the vehicle.
2. Reach behind the headlamp housing to
access the turn signal (inboard) bulb cap.
Turn Signal Bulb Cap
3. Firmly grab the cap and rotate it counter-
clockwise to unlock it.
Turn Signal Bulb Location
4. Squeeze the two tabs on the side of the bulb
socket and pull straight out from the lamp
assembly.
5. Disconnect the bulb from the wiring
connector and install the replacement bulb.
6. Install the bulb and connector assembly
straight into the lamp until it locks in place.
7. Install the turn signal bulb cap in the
headlamp housing and rotate clockwise to
lock in place.
Front Fog Lamps
The Front Fog Lamps use LED sources that are
not serviceable separately. The Front Fog Lamp
must be replaced as an assembly; see an
authorized dealer.
Front/Rear Side Marker Lamps
The Side Markers use LED lamps that are not
serviceable separately. The Side Markers must
be replaced as an assembly, see an authorized
dealer.
CAUTION!
If the access cap is not installed correctly
after bulb replacement, the lamp becomes
susceptible to dust, condensation, and water
intrusion. This may ultimately lead to an
inoperative lamp. If the access cap cannot be
installed correctly, please return to an
authorized dealer for proper repair or access
cap replacement if necessary.
21_LX_OM_EN_USC_t.book Page 262
Loading ...
Loading ...
Loading ...