Loading ...
Loading ...
Loading ...
5
RJ16-LOCK SERIES
ABOUT THE OVERHEAT PROTECTION FEATURE
The overheat protection feature operates when the power cord is plugged in but the inner pot is
empty of water. If the Hot Water Pot has shut off automatically, unplug the power cord from the
eletrical outlet and wait for the Hot Water Pot to cool, and then add water.
DISPENSING WATER
There are three ways to dispense water.
RE-BOILING WATER
When the Hot Water Pot is in Keep Warm Mode, use the Reboil button to boil the water.
The boiling light will illuminate once pressed.
• Once the water has re-boiled, the Keep Warm light will illuminate.
• Before boiling, ensure the water level is above the refill mark in water window.
• The re-boil function will be deactivated immediately after the water has finished
a re-boil cycle.
LOCK MODE
1. Press Lock button to activate Lock Mode and indicator light will turn on.
Lock Mode deactivates and locks both the manual dispense button and reboil button.
2. To deactivate Lock Mode, simply press the Lock button again. This reactivates
the Auto Dispense buttons and Reboil button. When Lock Mode is activated, the Keep
Warm and Reboil indicator lights will be off.
• NOTE: If you open and close the lid while the Hot Water Pot is on (even in Lock Mode), it will
continue to function without any change just as when the lid is closed. It will not automatically
shut off and the function indicator lights will not turn on or off.
• To manually lock the spout so no water can come out, rotate the Manual Push Dial on top
of the lid up to the red lock symbol. To unlock, simply turn the dial down to the blue unlock
symbol. NOTE: This does not affect any mode or function the Hot Water Pot may be
running in. This action simply locks the spout as an added safety feature.
Push the manual button on
the lid.
Press the dispense button on the
control panel.
Place a mug or cup under the
spout and press it against the
cup touch switch.
OPERATING INSTRUCTIONS
Loading ...
Loading ...
Loading ...