Loading ...
Loading ...
Loading ...
10 English
Troubleshooting
Unit is not plugged in. Plug Power Cord into electrical outlet.
Tip-over switch is not making contact with the floor. Place heater on a level surface to ensure tip-over switch is making
full contact with the floor.
Household circuit breaker / ground fault interrupter has tripped or blown a fuse. Reset circuit breaker / ground fault
interrupter, or replace fuse (See OPERATING TIPS below).
The unit has overheated. Automatic Safety Shut-Off has been initiated (See RESETTING YOUR VORNADO HEATER).
Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance.
Ensure unit is set to High Heat and Thermostat is set to highest Temperature setting.
Close all doors and windows to retain heat.
Allow the unit to fully distribute the heat throughout the room, this may take several minutes.
Power off and unplug the unit. On the bottom of the unit, there is a black disk. Push in 4-5 times ensuring it is not
stuck. Set unit down on flat surface. Be sure power cord is not under unit. Plug unit in and power on. Turn to highest
heat setting.
Unit fails to
power on.
Unit is not pro-
ducing sufficient
amount of heat.
Unit power on
but there is no
heat.
Problem Possible Cause and Solution
Loading ...
Loading ...
Loading ...