Loading ...
Loading ...
Loading ...
7
Mounting with the Supplied 'Hanger Bracket' (ML-45AW only)
The ML-45AW can be mounted horizontally or vertically.
1. Using appropriate screws/mounting hardware (not included), mount the bracket
with the supplied safety strap on the wall at the desired location (figure 3). Make
sure the bracket is straight.
2. Screw two 1-inch #12 screws (included) into the upper and lower holes spaced
2
3
/
8-inch (60 mm) apart on the back of the speaker’s enclosure. Do not screw them
all of the way in—make sure they protrude about
1
/
8-inch (3 mm).
3. Bring the speaker to the bracket and connect the cables as outlined in this manual.
Connect the safety strap to the speaker using the middle hole (figure 4). Mount the
speaker onto the bracket using an ‘in and down’ motion.
For horizontal mounting simply mount the bracket horizontally with the key hole slots
facing up. Follow steps 1 to 3 (above) to complete horizontal installation.
Wall-Mounting with Supplied ‘U-Bracket’ (ML-55AW, ML-65AW and ML-75AW)
These speakers can be mounted horizontally or vertically with the ‘U-Bracket’.
1. Unscrew the knobs from either end of the speaker.
2. Using appropriate screws/mounting hardware (not included), mount the bracket
and a safety strap (not included, see dealer) on the wall in the desired location.
Make sure the bracket is straight. In-wall speaker wire can then be directed through
the large opening in this bracket which allows connection from behind the speaker
terminals to hide the speaker wire.
3. Bring the speaker up to the bracket and connect the speaker cable as outlined below.
4. Pull the bracket slightly apart and
fit the speaker into the bracket, one
end at a time to avoid scratching the
enclosure (figure 5).
5. Screw the knobs through the holes
in the mounting bracket and into the
speaker. Angle the speaker to orient
towards the desired position. Tighten
the knobs snugly, but do not over-
tighten them.
Figure 5. Mounting speaker on the U-bracket.
Loading ...
Loading ...
Loading ...