Loading ...
Loading ...
Loading ...
Thermostat (T) - see Fig. 3
In order to maintain a certain room temperature, set the controller to
‘max.’. Operate the appliance at full power until the required room
temperature is reached. Set back the thermostatic controller until the
appliance switches off with an audible “click”. This temperature will be
kept almost constant by the thermostatic control switching on and off
automatically.Please note that the appliance can only be switched on
when the thermostat setting is higher then the room temperature.
Thermal Safety Cut-out
A thermal safety cut-out is incorporated in the heater to prevent damage
due to overheating. This can happen if the heat outlet was restricted
in any way. The heater will switch on once the obstruction has been
removed and the heater has cooled. If the cut-out continues to operate
intermittently, the heater should be switched off and a service agent
contacted.
Maintenance
WARNING: ALWAYS DISCONNECT FROM THE POWER SUPPLY
BEFORE ATTEMPTING ANY MAINTENANCE.
Light Emitting Diode
This re is tted with LED (Light Emitting Diode) bulbs in place of
traditional incandescent bulbs. These generate the same light levels as
traditional bulbs, but use a fraction of the energy consumed.
Recycling
For electrical products sold within the European
Community.
At the end of the electrical product’s useful life it should
not be disposed of with household waste. Please recycle
where facilities exist. Check with your Local Authority or
retailer for recycling advice in your country.
Cleaning
WARNING – ALWAYS DISCONNECT FROM THE POWER SUPPLY
BEFORE CLEANING THE HEATER.
For general cleaning use a soft clean duster – never use abrasive
cleaners. The glass viewing screen should be cleaned carefully with a
soft cloth. DO NOT use proprietary glass cleaners.
To remove any accumulation of dust or uff the soft brush attachment of
a vacuum cleaner should occasionally be used to clean the outlet grille
of the fan heater.
After Sales Service
Please see the separate Warranty leaet for details of your
Warranty & After Sales Service including contact details.
Should you require after sales information or assistance with this
product, please contact Glen Dimplex Australia on 1300 556 816
(AUS) / 09 274 8265 (NZ) or visit our website at www.dimplex.
com.au (AUS) / www.dimplex.co.nz (NZ).
Glen Dimplex Australia Pty Ltd.
1340 Ferntree Gully Road,
Scoresby,
VIC 3179,
Australia
www.dimplex.com.au
Ph: 1300 556 816
Fax: 1800 058 900
Glen Dimplex Australasia Ltd.
35 Harris Road,
East Tamaki,
Auckland
New Zealand
www.dimplex.co.nz
Ph: 09 274 8265
Fax: 09 274 8472
5336