Loading ...
Loading ...
Loading ...
Installation Instructions
REMOVE THE REFRIGERATOR DOOR
3
Tape the door shut with masking tape.
Remove the plastic washer, center hinge pin
and door thimble with the 3/8″ (10mm) socket
ratchet/driver.
Remove the tape and tilt the door away from the
refrigerator. Tilt the door and lift to free its bottom
socket from the pin in the bottom hinge bracket.
Ensure that the door thimble remains on the hinge
pin or inside door hinge pin hole located in the
bottom of the doors.
Set the door on a non-scratching surface with the
inside up.
CAUTION: Do not let door drop to the floor.
To do so could damage the door stop.
Plastic Washer
Center Hinge Pin
Center Hinge Bracket
Door Thimble
Door Thimble
A
B
C
TRANSFER CENTER HINGE
BRACKET TO THE LEFT
Remove the center hinge bracket with a Phillips
screwdriver.
On some models, you will need to remove the caps
from the screw heads before you can remove the
screws. Use the edge of a thin blade to gently pry the
caps off the screw heads. (A putty knife works well for
this.) Cover the blade with tape to prevent scratching
the paint.
Remove the three Phillip’s screws from the center
left side of the refrigerator. Screw them into the
holes on the right side. Replace the caps by
snapping them over the screws with your finger.
Place the center hinge bracket over the holes at
the center left side of the refrigerator. Insert and
tighten the three screws.
4
A
C
D
19
TRANSFER BOTTOM HINGE
BRACKET TO THE LEFT
Using a Phillips screwdriver, remove the bottom hinge
bracket, plastic washer, and door thimble from the
right side.
NOTE: If the door thimble is not on the hinge
bracket, check to see if it is stuck to the bottom of
the door.
5
Plastic Washer
Bracket with
Hinge Pin
Door Thimble
Screws
A
Remove the hinge pin from the hinge pin bracket by
removing the nut and the metal lock washer.
B
Metal Lock
Washer
Hinge Pin
Nut
Place the bottom hinge pin in the left hole. Reinstall
the metal lock washer and the nut.
On some models, you will need to remove the
caps from the screw heads before you can remove the
screws on the left side. Use the edge of a thin-blade
screwdriver to pry the caps off the screw heads
(a putty knife works well for this.) Cover the
blade with tape to prevent scratching the paint.
Remove the three Phillip’s screws from the bottom left
side of the refrigerator. Screw them into the holes on
the right side. On models with screw caps, insert screw
caps over the screws.
Place the bottom hinge bracket over the holes at the
bottom left side of the refrigerator. Insert and tighten
the three Phillip’s screws. Replace the plastic washer
and door thimble.
C
D
E
F
Plastic Washer
Hinge
Bracket
Door Thimble
Screws
B
Screw Cap
Loading ...
Loading ...
Loading ...