Loading ...
Loading ...
Loading ...
8 9
To Lock the Lid in Place: Position the lid on the container with the lid flaps midway
between the spout and the handle. Push the lid on to the container until it locks in
place. The lid must always be secured when processing, especially hot liquids that
may scald. Never operate the blender without checking to make sure the lid is
securely locked in place.
To Remove the Lid: Lift up on one lid flap while holding the container securely.
To Remove the Lid Plug: Rotate the lid plug anticlockwise from the ‘locked’
to ‘unlocked’ position and lift out.
Power Cord: Your machine is equipped with a long power cord. Store the unused
portion neatly underneath.
WARNING
Rotating Blades Can Cause Severe Injury.
DO NOT reach into the container
while the machine is running.
PARTS AND FEATURES
1. On/O Switch: The On/Off (or Power) Switch is on the right-hand side of the
machine base. The On/Off Switch controls the power to the machine. BEFORE
moving the On/Off Switch to the On (I) position, make sure the Start/Stop
Switch is in the Stop (
) position and the Variable Speed Dial is to the far left,
pointed at number 1. Move the On/Off Switch to the Off position whenever the
machine will be left unattended.
2. On/O Indication: When the Pulse (
) and Start ( ) symbols brighten, this
indicates that the machine is plugged in, the On/Off Switch is powered On and
power is flowing.
3. Start (
)/Stop ( ) Switch: Before starting, always make sure that the Variable
Speed Dial is to the far left, pointed at number 1. Lifting the Start/Stop Switch
to the Start Position (
) starts the rotation of the blades and begins the
blending process. Pressing down on the Start/Stop Switch to the Stop Position
(
) will stop the blending process.
4. Variable Speed Dial: The Variable Speed Dial selects blade rotation speeds
from 1 to 10 (low to high). Always begin the blending process with the
Variable Speed Dial set to 1. Make sure that the On/Off Switch is in the
On (I) position. Move the Start/Stop Switch to the Start (
) position. Rotate
the Variable Speed Dial to the desired speed setting. To stop the machine,
rotate the Variable Speed Dial back to 1 and move the Start/Stop Switch back
to the Stop (
) position. If the Variable Speed function is not working and the
blades only rotate at the lowest speed (Variable Speed 1) the blender must be
reset. Refer to Troubleshooting on Page 18.
5. Pulse Switch (
): Pressing down on the Pulse Switch will cause the machine to
blend at the speed setting shown on the Variable Speed Dial for as long as the
Pulse Switch is held down.
CONTROL PANEL
OFF
ON
OFF
ON
1
35
4
2
Loading ...
Loading ...
Loading ...