Loading ...
Loading ...
Loading ...
42
Installing an Internal Hard Disk Drive
Your system comes with an available bay to hold an additional hard disk
drive. The drive you install must not require front panel access. The hard
disk drive access light blinks when either internal drive is active.
1 Configure the jumpers on the new drive as a secondary master (see
your drive’s documentation for configuration instructions).
2 Remove the left side panel (see “Removing the Left Side Panel” on
page 22).
3 Remove the front panel (see “Removing the Front Panel” on page 24).
4 Remove the bottom panel (see “Removing the Bottom Panel” on
page 23).
5 Lay the system on its right side (left side faces up – see diagram that
follows).
6 Remove the two screws (A) that secure the drive holder.
! Before opening the system unit, save any open files, exit Windows, turn off
the power of the computer and all attached peripherals, and then unplug the
power cord.
KY0084.VSD
Drive connector
Power connector
Jumpers
Loading ...
Loading ...
Loading ...