Loading ...
Loading ...
RAPID CHANGE WEIGHT SYSTEMS
RAPID CHANGE
WEIGHT SYSTEMS
www.mxselect.com
SELECT
3
............................ Turn the Cradle over as pictured below, on a soft surface that will not damage Cradle finish.
Ensure the Cradle is stable.
..................................... Turn the Cradle over onto the Cradle Feet. Place Cradles where you intend to use them before
placing MX Dumbbell Handset into the Cradles.
PUSH FEET
FIRMLY
AGAINST
CRADLE
BEFORE
TIGHTENING
BOLT S
............................ Line up the holes in the first of the Cradle Feet with the holes in the Cradle. Put the Cradle Bolts and
washers in loosely. Push the Cradle Feet inwards firmly against the Cradle (direction of the arrow) and tighten the
Bolts. Repeat for each of the four Cradle Feet for each Cradle.
CHECK THAT ALL SCREWS ARE TIGHT.
......................... Remove the Cradle from the box and place on a flat surface.
Slotted holes in
Cradle Feet for
the Cradle Bolts
and washers.
Securing Cradle
Feet to Cradle
.............................. Check that the weight plate selector dial is set to 10, if not follow the “How to Select
desired training weight” instructions above, and set the dial to 10. Remove the MX Dumbbell Handset from
the Cradle, which will remain in the box. Place the MX Dumbbell Handset on a firm flat surface, being careful
not to damage the surface or the MX Dumbbell. CAUTION: The full weight (heavy) of the MX Dumbbell is
activated by Selecting 10 on the weight plate selector dial.
Threaded holes for
the Cradle Bolts
and washers.
Do NOT add the Cradle Feet if intending to install the MX SELECT Dumbbells on the Optional MX Dumbbell Stand.
Stop at Step 4 and then refer to the assembly instructions supplied with the MX Dumbbell Stand.
STEP THREE
STEP FOUR
STEP SIX
STEP FIVE
STEP SEVEN
Loading ...