Loading ...
Loading ...
Loading ...
5 Repeat steps 2 to 4 to store other favorite TV stations/learn other functions.
• If you only wish to watch the stations, stored under the FAVORITES keys, you can disable selection of
non favorite stations via the + PROG – keys as described under ‘Activating/deactivating child lock
function’.
• You can learn the FAVORITES keys functions from you original DVD remote control as well. For this,
repeat above steps.
Restoring the original functions of your remote control
Follow the instructions below to revert the SRU 1020 back to the factory default settings:
1 Keep keys s and E pressed simultaneously for 5 seconds, until the key
of the currently selected mode (TV or DVD) blinks twice and then remains
lit.
2 Press keys 2 / B, PROG + and 9 / D in that order.
– The mode key (TV or DVD) blinks twice to confirm that resetting was
successful.The SRU 1020 is now reverted back to the state it was when you
first took it out of the packaging.
4. Troubleshooting
• Problem
– Solution
• The device you want to operate does not respond when you press a key.
– Replace the old batteries with two new R03, UM4 or AAA type batteries.
– Point the SRU 1020 at the device and make sure that there are no obstructions between the SRU 1020 and
the device.
• The SRU 1020 does not respond properly to commands.
– Maybe you are using the wrong code.Try programming the SRU 1020 again using another code, which is
mentioned under the brand of your device, or reset for automatic search to find the right code.
• Your brand of device is not in the code list.
– Try to set the SRU 1020 automatically. See ‘Automatically setting the remote control’.
• None of the codes works during manual setting of the remote control.
– If that is the case, follow the instructions under ‘Automatically setting the remote control’.
• A code cannot be learned / a TV channel cannot be stored under the FAVORITES keys.
– The IR signal of the original remote control is out of range.The SRU 1020 only recognizes IR signals with a
carrier signal of 30-60 kHz.
– The SRU 1020 memory is full. Revert the SRU 1020 back to the factory default settings in order to create
memory space. See ‘Restoring the original functions of your remote control’.
– The SRU 1020 stopped the learning / programming process after 30 seconds for no IR signals were received.
Check if the original remote control is working properly.
9ENGLISH
Loading ...
Loading ...
Loading ...